Stimmen - 4, Durchschnittliche Bewertung: 4
(
)
)
|
Anleitung Zusammenfassung
Write and save the model and serial number of your unit below. Owner's Record Date Purchased __________________________________________________________ Purchased From __________________________________________________________ Installed By ______________________________________________________________ Serial Number ____________________________________________________________ Model___________________________________________________________________ Installer: Leave this manual for homeowner. Homeowner: Read this manual and keep for future reference. ALSO FIND MANUAL ON-LINE AT JACUZZI.COM Copyright© 2007 by Jacuzzi© Whirlpool Bath Products BE76000F • December 2007 ENGLISH Jacuzzi© Whirlpool Bath: Installation and Operation Page BE76000F • December 2007 IMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS SAVE THESE INSTRUCTIONS INSTRUCTIONS PERTAINING TO A RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS Warning: When using this unit, basic precautions should always be followed, including the following. Warning: Use this unit only for its intended use as described in this manual. Do not use attachments not recommended by the manufacturer. Danger: To reduce the risk of injury, do not permit children to use this unit unless they are closely supervised at all times. Warning: Never drop or insert any object into any opening. INSTALLATION Note: This is a professional grade product. A knowledge of construction techniques, plumbing and electrical installation according to codes are required for proper installation and user satisfaction. We recommend that a licensed contractor perform the installation of all Jacuzzi© Whirlpool Bath products. Our warranty does not cover improper installation related problems. Note: Install this unit in accordance with the Canadian Electrical Code, Part 1. Caution: This equipment is intended for indoor use only. Install the equipment in accordance with these instructions. Use supply wires that are suitable for 75°C, including the temperature rating of the supply conductors to be used. This unit should be electrically grounded and installed by a licensed contractor, electrician, and plumber. Building materials and wiring should be routed away from the motor/pump or blower or other heat producing components of this unit. A pressure wire connector is provided on the exterior of the motor/pump and heater to permit connection of an No. 8 AWG (8.4 mm) solid copper bonding conductor between this unit and all other electric equipment and exposed metal in the vicinity, as needed to comply with local requirements. DANGER: Risk of electric shock. Connect only to a circuit protected by a ground fault circuit interruptor (GFCI). Warning: This unit must be connected only to a supply circuit that is protected by a 15 A ground fault circuit interrupter (GFCI). Such a GFCI should be provided by the installer and should be tested on a routine basis. To test the GFCI, push the test button. The GFCI should interrupt power. Push the reset button. Power should be restored. If the GFCI fails to operate in this manner, the GFCI is defective. If the GFCI interrupts power to the bathtub without the test button being pushed, a ground current flowing, indicating a possibility of an electric shock. Do not use this hydromassage bathtub. Disconnect the hydromassage bathtub and have the problem corrected by a qualified service representative before using. Warning: (For permanently connected units) A green-colored terminal (or a wire connector) marked “G,” “GR,” “GROUND,” or “GROUNDING”) is provided within the terminal compartment. To reduce the risk of electric shock, connect the terminal or connector to the grounding terminal of your electric service or supply panel with a conductor equivalent in size to the circuit conductors supplying the equipment. For built-in and drop-in units, install to permit access for servicing. OPERATION CAUTION: Test the ground fault circuit interrupter protecting this appliance periodically in accordance with manufacturer’s instructions. Warning: Risk of hyperthermia and possible drowning: Water temperature in excess of 104°F (40°C) may be injurious to your health. Check and adjust water temperature before use. Warning: Prolonged immersion in hot water may induce hyperthermia. Hyperthermia occurs when the internal temperature of the body reaches a level several degrees above the normal body temperature of 98.6°F. The symptoms of hyperthermia include an increase in the internal temperature of the body, dizziness, lethargy, drowsiness and fainting. The effects of hyperthermia include: a. Failure to perceive heat. b. Failure to recognize the need to exit the spa or hot tub. c. Unawareness of impending hazard. d. Fetal damage in pregnant women. e. Physical inability to exit the spa or hot tub. f. Unconsciousness resulting in danger of drowning. Warning: Risk of fetal injury: Pregnant or possibly pregnant women should consult a physician before using a hydromassage bathtub equippe...