Stimmen - 1, Durchschnittliche Bewertung: 5 ( )

Hersteller: Dimplex Dateigröße: 170.43 kb Dateiname: Unterrichtssprache:

Drill and plug the wall to suit - see Fig. 3. W Fig. 3 Step 2 The hex. stud screw in the slot has to be removed using the allen key provided first, to separate the inner ‘Z’ and outer ‘W’ sleeves of the wall brackets - see Fig. 4. Z Mount the four outer sleeve wall brackets in line with the drilled outW holes using the screws provided - see steps 1 - 4 in Fig. 3. Note: the brackets have slot holes to allow for possible adjustment later. Step 3 X Remove the cap ‘Y’ from the inner sleeve assembly, unscrew the nut and remove the rail support ‘X’ - see Fig. 5. On the inner side (wall) of the towel rail position the inner sleeve between the cross rails as indicated in Fig. 1. Position the rail support to receive the bolt on the inner sleeve and hand tighten with the nut - see Fig. 3. Slide into position (see suggested positions in Fig. 1). Y W Step 4 Lift the towel rail now with the inner sleeve assembly in position, and align with the outer sleeve previously fixed to the wall. When all four inner sleeves are inserted correctly into the outer sleeves of the brackets tighten each nut fully. Replace the cap ‘Y’ and the hex. stud screw. The distance the towel rail can be positioned from the wall can be varied by adjusting the hex. stud screws. When in the desired location, tighten fully to secure the towel rail to the wall. To assist with the alignment of the outer ‘W’ and inner ‘Z’ sleeves the outer sleeve may be adjusted using the slot provided, refer to Note in step 2. Drying and Airing Towels It is recommended that for efficient drying, no more than two layers of towels or similar fabric should be draped over the rail. Items should be placed evenly over the whole surface of the rail where possible. It is not advisable to leave very damp towels or clothes on the towel rail when not in use, as this may in time, affect the paint finish. The rail, although hot to the touch is not hot enough to scorch or burn fabrics. However, soap and detergents remaining in articles after washing can cause discoloration. Therefore care should be taken to thoroughly rinse articles before airing. Wiring Wiring Diagrams : for DTR175 see Fig. 6, and DTR350 see Fig. 7. Fig. 4 Fig. 5 Fig. 6 C2 C1DTR 175 A N L N L A -Terminal Block C1 -Cut-out 1 C2 -Cut-out 2 A LN C1 C2 LN DTR 350 A -Terminal Block C1 -Cut-out 1 C2 -Cut-out 2 Fig. 7 Operation (Electrical) Heat will be distributed along each of the rails. Some variation in the temperature across the surface of the rail is also normal. When the appliance is covered the heating pattern of the rails may alter slightly. Cleaning The finish on your towel rail can be maintained by occasionally wiping over with a damp cloth and lightly finishing with a soft dry cloth. This should only be carried out when the rail is cold. Do not use abrasive cleaning powders as this could damage the surface finish. Recycling For electrical products sold within the European Community. At the end of the electrical products useful life it should not be d...

Herunterladen

Geben Sie zwei Ziffern: