Stimmen - 3, Durchschnittliche Bewertung: 4.3 ( )

Hersteller: Aruba Spa Dateigröße: 214.13 kb Dateiname: Unterrichtssprache:

Check with your local spa store. 7. Alkalinity levels need to be tested weekly. 8. Water testing should be done at home using test strips or an accurate test kit, or by taking your water to a spa or pool retail outlet and having them test your water sample (you should expect to pay a nominal fee for this service). CHEMICAL TABLE OF EQUIVALENTS CHART 15 ml = 1 TBS 4 TBS = 1/4 cup 15 g = 1 TBS PROBLEMS ASSOCIATED WITH IMPROPER WATER BALANCE Low pH: Low pH:Low pH: • causes rapid sanitizer loss. • causes eye irritation and itchy skin. • corrodes equipment Solution: add pH increaser (pH up) to raise the pH levels. High pH: High pH:High pH: • forms scale. • causes short filter runs. • clouds water. • reduces sanitizer efficiency. Solution: add pH decreaser (pH down) to lower the pH levels. Low Sanitizer Levels: Low Sanitizer Levels:Low Sanitizer Levels: • allows growth of bacteria and viruses in spa water. Solution: refer to Chemical Maintenance, Initial Start Up Procedures, page 19. Causes of pH change: Causes of pH change:Causes of pH change: • adding water. • rain. • bather load. • adding chemicals. • dust. • algae. C CCARE FOR ARE FORARE FOR Y YYOUR SP OUR SPOUR SPA AA DRAINING YOUR SPA Drain and re-fill the spa as indicated below: Average Use: Every 60 - 90 days Heavy Use: Every 30 days After Parties: Drain Before draining your spa you may add whirl-o-clean to the warm water and start the pump for about 30 minutes. This will help in eliminating grease and oils in the plumbing and jets. WARNING Do not leave your spa exposed to direct sunlight when there is no water in the spa. Exposure to direct sunlight could damage the spa shell and void your warranty. T TTo drain the spa: o drain the spa:o drain the spa: 1. Turn off all power to your spa. 2. Attach a hose to the hose bib at the bottom of the spa and gravity drain by the siphon method. 3. Clean the surface (see “Spa Surface” later in this section). 4. Refill the spa. Follow the initial start-up procedures to re- prime the spa. WARNING Make sure you replace your filter cartridges at least once every six months. FILTER CLEANING 1. Your spa is equipped with a top access filter. To access the filter cartridge, remove the skimmer basket and filter cartridge. 2. Once a week remove filter, just hose it off well and replace it. Every 4-6 weeks properly clean your filter in a filter cleaner solution. Soak 4-6 hours (or overnight). 3. Once cleaned, re-install filter cartridge and skimmer basket. 4. How often the cartridge filter needs to be cleaned depends largely upon how many bathers are using the hot tub. With average use we recommend cleaning the cartridge filters approximately every 4-6 weeks. However, more frequent or greater numbers of people may require more frequent cleaning. IMPORTANT Be sure to thoroughly rinse the filter cartridge to thoroughly remove any cleaning agents. If this is not accomplished, foaming of the water may occur during the filter cycle of the hot tub. SPA SURFACE Your spa has a very high quality acrylic surface. Stains and dirt will generally not adhere to the surface. Do not use household products for cleaning the spa surface. Be careful of detergents as they may contain phosphates that may contaminate the water and will cause foam build-up. Also, many cleaning agents contain abrasives which will scratch the surface, and therefore must not be used. After cleaning, be sure to rinse the surface with water to ensure all excess cleaning solution is properly diluted and removed. This will avoid unnecessary reaction of skin irritations from chemical contact to the body. Follow product recommendations. You may also wish to periodically polish the acrylic surface with spa polish (Gel Gloss). WARNING Do not use caustic solutions as they may damage the spa shell surface and void the warranty. WARNING When cleaning the surface use only acrylic cleaners. CABINET When properly cared for the Cedar cabinet of your spa will maintain its good looks for many years. All woods react to the elements differently by expanding and contracting, so make sure you re-stain the wood every 10 to 12 months with an oil based stain to thoroughly protect the wood. Clear wood finish can be used as a good wood sealing agent. The wood must be properly maintained. COVER With safety and convenience in mind the spa cover has been designed with child safety latches and a slope designed to create a natural run-off for rain water. Please ensure the use of spa straps and latches to secure the cover when not in use. This will help to discourage unsupervised children from entering the spa and keep the spa cover secure in high-wind conditions. DO NOT allow snow to build up on the cover as it is not intended to bear weight. Weight on the cover may cause the edges of the cover to curl, or progressively warp and bow the cover, or in extreme cases cause the foam inserts to break. To avoid this keep all weightbearing objects off of the cover. Water and snow must be swept off to keep the...

Herunterladen

Geben Sie zwei Ziffern: