Stimmen - 3, Durchschnittliche Bewertung: 4.3
(
)
)
|
Anleitung Zusammenfassung
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. GENERAL INFORMATION The Warm & Serve Drawer can be used: • As a stand alone appliance • As a combination Warm & Serve Drawer with a 30" (76 cm) built-in oven mounted above IMPORTANT: The warmer drawer must be installed on a leveled surface from left to right, rear to front and the surface must be capable of supporting 100 lbs (45 Kg). D G H* FE J** B C A P/N 318201811 (0711) Rev. D English – pages 1-2; Espanol – paginas 3-4 Francais – pages 5-6; Notes - pages 7-8 D AB F E C Warm & Serve Drawer Dimensions Stand Alone Installation Combination Warm & Serve Drawer/ 30" (76 cm) Built-in Oven Installation NOTE: A 60" (152 cm) long cable is supplied with the Warm & Serve Drawer. A. HEIGHT B. WIDTH C. DEPTH 11 ." (28,6 cm) 30" (76,2 cm) 23 3/8" (59,4 cm) D. CUTOUT E. CUTOUT F. CUTOUT HEIGHT WIDTH DEPTH Min. 9 7/8" (25,1 cm) 28 ." (72,4 cm) 24" (61 cm) Max. 10 ." (26 cm) 28 ." (73 cm) D. CUTOUT E. CUTOUT F. CUTOUT G. HEIGHT HEIGHT WIDTH DEPTH Min. 9 7/8" (25,1 cm) 28 ." (72,4 cm) 24" (61 cm) 1 ." (4,4 cm) Max. 10 ." (26 cm) 28 ." (73 cm) FLOOR Warm and Serve Cutout Warm and Serve Drawer 60" (152 cm) Cord Minimum distance to floor 41/2" (11,4 cm) IMPORTANT: The Warm & Serve Drawer runs off a single phase three-wire 120 volt, 60 hertz, AC only electrical supply with ground. H* = 11 5/8" (29.6cm) Min. is a Critical dimension and has to be respected. Depends on critical dimension H Bottom of oven cutout Caution: Two 3" (7,6 cm) wide X 3/4" (1,9 cm) thick planks have to be install and they should be able to support 200 pounds. (90,7 Kg) A. HEIGHT B. WIDTH C. DEPTH 11 ." (28,6 cm) 30" (76,2 cm) 23 3/8" (59,4 cm) 29." (74.9cm) J** = 3" (7.6cm) Max. Electrical Junction Box for wall oven must be lower than the warmer drawer cutout. Printed in the USA WARM & SERVE DRAWER INSTALLATION INSTRUCTIONS Important Notes to the Installer 1. Read all instructions contained in these installation instructions before installing appliance. 2. Remove all packing material from appliance before connecting the electrical supply. 3. Observe all governing codes and ordinances. 4. Be sure to leave these instructions with the consumer. Important Note to the Consumer Keep these instructions for future reference. IMPORTANT SAFETY INSTRUCTIONS • Be sure your appliance is installed and plugged into a 120 Volt grounded outlet. • This appliance must be electrically grounded in accordance with the National Electrical Code ANSI/ NFPA No. 70—latest edition in the United States, or CSA C22.1, Part 1 in Canada, and local code requirements. Tools You Will Need Figure 2 Use screws supplied to attach drawer to front of cabinet. Model and Serial Number Location The serial plate is located as shown below. When ordering parts for or making inquiries about your Warm & Serve Drawer, always be sure to include the model and serial numbers and a lot number or letter from the serial plate on your Warm & Serve Drawer. Phillips® Screwdriver Pencil Ruler or Tape Measure and Straight-edge Hand Saw or Saber Saw Spirit Level Warm & Serve Drawer Installation 1.Locate the 2 anti-tip brackets supplied as shown on fig. 1. c/c 25 5/16" (64.3 cm) 24" (64.3 cm) Max. 23 5/8" (60 cm) Min. c/c 12 21/32" (32.15 cm) Figure 1 Combination Warm & Serve Drawer and Cooktop Installation 2.Slide drawer into cutout opening until front frame of drawer is flush against cabinet. Be careful not to pinch electrical cord. Serial Plate Location A Minimum Depth Spacing To Clear Cooktop Burner Box 3.Remove the drawer as instructed in the Use & Care Guide and secure drawer housing to cabinet using the 3 nickel-plated screws supplied (see Figure 2). Do not overtighten screws. 4.The 60" (152 cm) appliance power cord can now be connected into the 120 Volt outlet. 5.Proceed with mounting built-in oven above the drawer (if applicable). Follow installation instructions provided with built-in oven. Make sure to use anti-tip brackets supplied with the built-in oven. 2 Electric Cooktop Spacing "A" Gas Cooktop E30IC75, E36IC75 4.5" (11.43cm) E30EC65, E36EC65 6.0" (15.24cm) E36EC75 7.5" (19.05cm) 8.5" (21.59cm) E36GC75 E30EC70, E36EC70 5.0" (12.7cm) INSTRUCCIONES DE INSTALACION PARA EL CAJON CALENTADOR 3 Min. 24" (61 cm) Max. Dimensiones del cajon calentador Instalacion de la unidad independiente A. ALTO B. ANCHO C. LARGO 11 ." (28,6 cm) 30" (76,2 cm) 23 3/8" (59,4 cm) D. ALTURA DE LA ABERTURA 9 7/8" (25,1 cm) 10 ." (26 cm) E. ANCHO DE LA ABERTURA 28 . " (72,4 cm) 28 . " (73 cm) F. LARGO DE LA ABERTURA Instalacion de la combinacion cajon calentador y horno de 30" (76 cm) integrado LA INSTALACION Y EL SERVICIO DEBEN SER EJECUTADOS POR UN INSTALADOR CALIFICADO. IMPORTANTE: GUARDE ESTAS INSTRUCCIONES PARA EL USO DEL INSPECTOR LOCAL DE ELECTRICIDAD. LEA Y GUARDE ESTAS INSTRUCCIONES PARA FUTURAS REFERENCIAS. PARA SU SEGURIDAD: No almacen...