Stimmen - 0, Durchschnittliche Bewertung: 0
(
)
)
|
Anleitung Zusammenfassung
3 kg drying. I (AIRING COLD) max. 3 kg For all types of fabrics. For freshening up or airing of items of laundry that have been worn for a sho rt period of time. After drying: laundry is to be ... ....irone d ..lightly ironed dr y ....not irone d ..passed through a mangle COTTON max. 7 kg IRON DRY .......... MIX max. 3 kg For mixed items of laundry made of cotton and easy-care fabrics. CUPBOARD DRY/IRON DRY 7 Instructions en for installation and use Tumble dryer WD 260100 Installation . Scope of delivery: dryer, installation and instruction manual, basket for woollens (depending on the model). . Check dryer for transport damage. . The dryer is very heavy. Do not lift without assistance. . Be careful to avoid sharp edges. . Do not install in a room which is susceptible to frost. Water may cause damage once it starts to freeze. . If in doubt, have the appliance connected by a specialist. . Do not lift the dryer by any of the protruding parts (e.g. the door) as they may break off. 1. Setting up the dryer . The appliance plug must always be accessible. . Ensure that the appliance is installed on a clean, level and firm surface. . Do not obstruct the air inlet on the front of the dryer. . Keep the area around the dryer clean. . Level the dryer using the threaded feet. Use a spirit level. . Do not remove the threaded feet under any circumstances. Remove all accessories from the drum. The drum must be empty. Fr2. Mains connection see safety information ..Page 13. . Connect to an AC earthed socket. If in doubt, have the socket checked by a specialist. . The mains voltage and the voltage shown on the rating plate (..Page 10) must be the same. . The connected load and necessary fuse protection are specified on the rating plate. ost protection Make sure that the air inlet remains unobstructed Clean and level Do not install the dryer behind a door or sliding door, which could prevent or restrict opening of the dryer door. This will prevent children from locking themselves in and putting their lives in danger. Do not operate the dryer if there is a danger of frost. Preparation 1. Empty the condensation container ..page 4. 2. Select any programme using the programme selector. 3. Press the START/STOP button ..condensation is pumped into the container. 4. Wait 5 minutes and then empty the condensation container again. 5. Turn the programme selector to OFF. Transport 8 . Preparation of dryer ..see Frost protection. . Transport the dryer in a vertical upright position. . Following transportation leave the dryer to stand for two hours. There may be residual water in the dryer. This can leak out if the dryer is at an angle. 9 Only when the appliance is switched off. Care and cleaning Heat exchanger The heat exchanger of the dryer is cleaned automatically when drying is in progress, Cln appears in the display panel. Do not pull the condensation container out during the cleaning process. Dryer housing, control panel, air intake Wipe with a soft, damp cloth. Do not use harsh cleaning agents or solvents. Remove detergent and cleaning agent residue immediately. Some water may collect between the window and the seal during drying. This does not affect the proper operation of your dryer in any way. Filter in the condensation tank The filter is cleaned automatically when the condensation container is emptied. However, the filter should still be cleaned regularly under running water. This prevents stubborn deposits/dirt from building up. Cleaning is only required if the symbol ..flashes again in the display panel after the condensation container has been emptied. 1. Pull out the condensation container. 2. Pull the filter out of its snap-in lock. 3. Clean the filter under running water or in the dishwasher. 4. Refit the filter. 5. Insert the condensation tank so that it locks into place. Only operate the dryer with the filter inserted. Moisture sensor The dryer is equipped with stainless-steel moisture sensors. These measure how damp the laundry is. After long periods of use, a fine layer of limescale can form on the moisture sensors. 1. Open the door. 2. Clean the moisture sensors using a damp sponge with a rough surface. Do not use steel wool or other abrasive materials. 10 Technical data ..Dimensions (DxWxH) 60 x 60 x 85 cm (height adjustable) Weight approximately 53 kg Max. capacity 7 kg Condensation container 4.0 l Connection voltage 220-240 V Connected load max. 1000 W Fuse protection 10 A Ambient temperature 5 -35 °C Product number/ Production number Inside of door You can find the rating plate on the back of the dryer. ..Consumption rates These are guide values determined under standard conditions. Spin speed in rpm (residual moisture) Drying time** in min. Energy consumption** in kWh COTTON 7 kg CUPBOARD DRY* 1400 (approx. 50 %) 112 1.35 1000 (approx. 60 %) 131 1.60 800 (approx. 70 %) 150 1.86 IRON DRY* 1400 (approx. 50 %) 80 0.96 1000 (approx. 60 %) 99 1.22 800 (approx. 70 %) 118 1.47 EASY CARE 3.5 kg CUPBOARD DRY* 800 (approx...
Dieses Handbuch ist für folgende Modelle:Andere Küchengeräte - WD260100/06 (1.48 mb)
Andere Küchengeräte - WD260100/12 (1.48 mb)
Andere Küchengeräte - WD260100/15 (1.48 mb)
Andere Küchengeräte - WD260100/16 (1.48 mb)