If water flows in and stops when you pull it out, the Valve is working fine. Repeat this test a few times. The problem may be in the Probe or Water Level Control Board. If the water does not flow in when the cord is plugged into an electrical outlet, the Solenoid coil may be damaged, opened or the valve may have an obstruction preventing the water from flowing in. Clean or replace it. C) Dual Probe Test If lack of water persists, check the probe as follows: Turn on the power and water supply. Check inside the tank to make sure the water is below the Probe. Pull the BLUE wire and terminal OFF the Probe rod. If water still does not flow after the wire is disconnected from the Probe, the problem may be in the Solid State Dual Level Control Board. If water starts flowing into the tank, the Probe may be grounded, due to excessive liming. Check with Ohm meter. Clean or replace probe. D) Dual Probe Liquid Level Controller Test Check the Controller as follows: 1. Make sure there is power input to the Controller at the terminals AC1 & AC2 Your voltmeter should read 115 Volts. It should read the same at terminals AC1 & FILL when the water level is low. This is the output power to actuate the coil of the Solenoid Valve to open it. The lack of voltage at terminals AC1 & L-LEVEL or H-LEVEL indicates that the Controller is not working properly. 2. Make sure all wire connections are tight, including ground. 3. If after this, the Controller is still failing to open the Water Inlet Valve, replace it. 5 TROUBLESHOOTING GUIDE WARNING: To reduce the risk of electrical shock unplug the dispenser power cord before repairing or replacing any internal components of the unit.. Before any attempt to replace a component be sure to check all electrical connections for proper contact. PROBLEM PROBABLE CAUSE REMEDY A Dispensing unit unplugged Reconnect dispensing unit B No power from Terminal Block Check the Terminal Block for loose wire C Defective Bulb Replace Bulb. D Defective Ballast. Replace Ballast. 1 Light Display not lit. No power. E Loose Bulb in socket. Make sure bulb is seated properly in socket. A Water supply OFF. Turn water ON. B Clogged inlet screen (Water Inlet Valve). Disconnect water line and clean inlet screen. C Inoperative Water Inlet Valve. Check connection, if needed replace Valve. 2 No water when Rinse Switch is ON. D Loose electrical connection. Check all electrical connections. A No product in Hopper. Add product. B Auger not working. Engage Hopper/Nut to Motor Gear (See section VI). C Damaged, loose, or missing Agitator Gear. Replace Agitator/Auger Gear (See section VI). D Inoperative Auger Motor or Relay. Check connections of Motor, Relay and/or Switch, if needed replace components. E Hopper outlet clogged Clean Hopper and check Cartridge Heater. 3 No product when Dispense Button is pressed F Faulty Coupling. Replace damaged Coupling components. A Leaking Water Inlet Valve. Clean/check fittings of Water Inlet Valve. Replace Water Inlet Valve if nee...

Dieses Handbuch ist für folgende Modelle:
Andere Küchengeräte - GB1HC-CP (547.88 kb)
Andere Küchengeräte - GB1CP (547.88 kb)
Andere Küchengeräte - GB1HC-CP-PC* (547.88 kb)
Andere Küchengeräte - GB2-CP (547.88 kb)