Stimmen - 4, Durchschnittliche Bewertung: 4.3 ( )

Hersteller: Follett Dateigröße: 3.69 mb Dateiname: Unterrichtssprache:

The equipment is new and unused. 2. A return authorization number has been issued by customer service within 30 days after shipment. 3. Follett receives the equipment at the factory in Easton, PA within 30 days after issuance of the return authorization number. 4. The equipment must be returned in Follett packaging. If the packaging has been damaged or discarded, Follett will forward, at the customer’s expense, new packaging. Note: Return freight charges are the responsibility of the customer. If equipment is returned and is damaged because of improper packaging, Follett Corporation will not be held responsible. Credit will be issued when: The equipment has been inspected by Follett and deemed suitable to be returned to stock. Note: A 15% restocking charge will be deducted from the credit. If the cost to return the product to stock exceeds 15%, the actual cost will be deducted. DROP-IN • SATELLITE-FILL self-contained 4 self-contained DROP-IN • SATELLITE-FILL Carefully unpack and inspect the contents of your Follett icemaker. Unpack 1 1/2" 1/2" . . . . . . 1.1 Unpack icemaker DROP-IN • SATELLITE-FILL self-contained 5 1/4. 1' . . . . 208264 Stock Module Identification Plate Service No. Module No. Product OMRESSOR THERMALLY PROTECTED Easton Pennsylvania AMPS AMPS VOLTS PHASE SINGLE CHARGE LOW SIDE PART NO PSIG THE USA MADE IN OZ R C R HZ UL L NSF U NEMA 6-15 HCC1000A/W HCC1400A/W NEMA 6-20 HCE1000A/W ‡ requires 15 amp circuit 1.50 mm2 wire HCE1400A/W ‡ requires 20 amp circuit 4.00 mm2 wire Prepare the installation site. Site preparation 2 2.1 Provide drainage, water supply and electrical power to within 6 feet (2m) of icemaker in accordance with local and national codes. Outdoor installation is not recommended and will void warranty. Electrical . • HCC1000(A/W)JS 208-230/60/1-15 amps • HCC1400(A/W)JS 208-230/60/1-20 amps • HCE1000(A/W)JS 230/50/1-15 amps‡ • HCE1400(A/W)JS 230/50/1-20 amps‡ (HCE1000A/W Requires 15 amp circuit 1.50 mm2 wire) (HCE1400A/W Requires 20 amp circuit 4.00 mm2 wire) ‡ Plug must be provided by end user & must conform to standard EN 60 335-2-24 of the end destination. Potable water supply . • 10-70 psi (69-483kpa) • 45 to 90 F (7 to 32 C) • Follett recommends the use of an in-line water filtration system (item# 00130286) Condenser water supply for water-cooled systems . • 10 psi min.; 150 psi max. (69kpa min.; 1034kpa max.) • 45 to 90 F (7 to 32 C) • 1.5 gallons per minute (5.68 liters per minute) Drain . • The drain line from the icemaker must have at least 1/4" per foot pitch (6,4mm/0,3m) 2.1 Installation site requirements 6 self-contained DROP-IN • SATELLITE-FILL 12" (304,8mm) min. 4" (101,6mm) . . . . . . . . . . Hot Water . Prepare the dispenser. Dispenser preparation 3 • Determine best route for ice transport tube run. Note: 12" (304,8mm) clearance is required. • Drill 1 3/4" (44,5mm) hole through either side of dispenser . • Install gasket . onto bulkhead fitting . • Attach bulkhead fitting with flat up . and tighten bul...

Herunterladen

Geben Sie zwei Ziffern: