Stimmen - , Durchschnittliche Bewertung: ( )

Anleitung Bakers Pride Oven, modell Hot Food Display Cabinets CHS/2N

Hersteller: Bakers Pride Oven
Dateigröße: 285.3 kb
Dateiname:

Unterrichtssprache:

Das Dokument wird geladen, bitte warten

HerunterladenSchließen

Das Dokument wird geladen, bitte warten

HerunterladenSchließen

• Do not attempt to clean the elements or lamp. • Do not use a water jet or steam cleaner. • Do not use abrasive or corrosive cleaners. GLASS All flat and curved glass panels fitted to “Hot Shop” holding cabinets are manufactured from toughened or tempered safety glass. IMPORTANT:- Take care when cleaning or handling glass, allow glass to cool before cleaning, for best results use a clear liquid smear free glass cleaner. Do not use abrasive cleaners or scouring pads on glass panels. 8 The Front Curved glass and Side glass panels can be removed for maintenance or cleaning as follows: CURVED GLASS • Lift front curved glass section forwards from the top. (The front glass section is attached to the cabinet at the bottom by the aluminium strip). Hold the glass in the forward position for cleaning or tilt forwards and lift out of track for complete removal IMPORTANT:- Do not leave the front curved glass section unsupported in the open position. • Slide the side panels our from the front • Replace in reverse order LAMPS The “Hot Shop” display cabinets are illuminated with T5 Fluorescent lamps fitted with a protective over tube. Replace failed lamps as soon as possible as follows:- • Remove any food items from the cabinet, then switch “off”. • Disconnect the cabinet from the power supply, allow to cool. • Remove sliding doors. • Remove mezzanine shelf and any food pans. • Remove lamp, grip lamp through lamp cover & twist . turn clockwise towards front of cabinet to release ends. • Replace with a new lamp of the correct voltage and rated input. Important:- Do Not forget to refit lamp cover. Replace cover if damaged. Important:- In the event of a glass breaking whilst the cabinet is in use, any food items held at that time must be wasted. The cabinet must be thoroughly inspected and cleaned before future use. 9 TROUBLE-SHOOTING 1. Read and understand the Operating Instructions. 2. Clean the unit each day. 3. Refer to the troubleshooting guide if the unit does not operate properly. 4. Have only an authorised serviceman check and repair unit when needed PROBLEMUnit fails to operate 1. No Power 2. Circuit breaker is off No Heat 1. Circuit breaker is off 2. Defective heating element 3. Defective Simmerstat 4. Loose wire or bad connection Holding Temperature not Adequate 1. Door is open 2. Food temperature is too low 3. Cabinet temperature too low Cabinet too hot or steamed up 1. Food temperature is too high 2. Food items drying out 3. Cabinet steamed up CORRECTIVE ACTION 1. Assure that power supply is sound 2. Rest circuit breaker 1. Check circuit breaker 2. Replace heating element 3. Replace Simmerstat 4. Repair 1. Keep doors closed when not in use 2. Food under cooked / over cooked or held too long (See Holding Times) 3. Adjust Simmerstat, allow time for cabinet to pre-heat before loading products. 1. Adjust Simmerstat, check water level 2. Food over cooked or held too long, Simmerstat set to high, water drawer empty. 3. Hot water used when cabinet switched on from cold. Hot food loaded before cabinet has been preheated. Simmerstat set to Full 10 GASTRONORM PANS & SPARE PARTS Contact your distributor or the spares department at BKI for spare gastronorm pans or replacement lamps, quoting the following code numbers, check the appliance rating plate for model type GASTRONORM CONTAINER SIZE GN 1/1 GN 1/1 WIRE GRID (1/1) GN 2/3 GN 2/3 GN 1 /2 GN 1 /2 GN 1 /3 GN 1 /3 Spare Parts List DEPTH CAPACITY (Ltrs) CODE 40mm 5 PN001 65mm 9 PN006 TY013 40mm 3 PN012 65mm 5.5 PN010 40mm 2 PN013 65mm 4 PN009 40mm 1.5 PN014 65mm 2.5 PN008 PART CODE DESCRIPTION CA 069 Element, 2500 W (CHS/N2) CA 070 Element, 2000 W (CHS/N3) CO 009 Schrack relay, 25A (RM 805730) (CHS/N3) FA 010 Fan GL 060 Curved Glass (CHS/N2) GL 069 Curved Glass (CHS/N3) GL 121 Side Glass (All models) LI 023 Fluorescent lamp, T5, 535mm, F13W / White LI 026 Lamp over-tube LI 024 T5 lamp holder, . turn, snap-in LI 025 Ballast 13W, screw terminal LI 027 Fluorescent starter, glow type, 4 – 80W LI 028 Starter holder LI 012 Neon indicator, amber, round SI 001 Simmerstat c/w knob SW 019 Switch, rocker c/w neon 11 ...