Stimmen - 4, Durchschnittliche Bewertung: 4.3
(
)
)
|
Anleitung Zusammenfassung
Avoid direct sunlight or direct heat sources such as a stove or a heater. If this cannot be avoided, the following minimum distances should be maintained: From cookers : 3.00 cm From heaters : 3.00 cm From cooling devices : 2.50 cm • Make sure that sufficient room is provided around the appliance to ensure free air circulation. Fit the two plastic wall spacers supplied with the appliance rotating 1/4 turn to the condenser at the back of the appliance (Fig. 3). • The appliance should be located on a level surface. The two front feet can be adjusted as required. To ensure that your appliance is standing upright adjust the two front feet by turning clockwise or counter-clockwise, until the product is in firm contact with the floor. Correct adjustment of feet avoids excessive vibration and noise. Electrical connections Warning This appliance must be grounded. • Check whether the power type and voltage your region corresponds to the one stated on the rating label inside the appliance. • The electrical safety of the appliance is only assured when the grounding system in the house is installed in accordance with regulations. • When placing the appliance, do not let the power cable get stuck under it; otherwise the cable will be damaged. • Ensure that the plug remains readily accessible. Do not use a multiple adapter bar or an extension cable. • The electrical specifications of your appliance is given on the rating label located inside the appliance. • Route power cable to allow easy connection and disconnection after installation. • A contact separator should be used if the power cable is not accessible. (for built-in models) Get to know your appliance Prior to startup Before you start operating your appliance, the following points should be re-checked for safety: • Is the appliance standing level on the floor? • Is there sufficient space for good air circulation? • Is the interior clean? (Also see the section ‘Cleaning and care’) • Set the thermostat knob half way between 1 and 4 or Min. and Max. • Now connect the appliance to the mains. Do not place foodstuff into the appliance until the temperature has reached the desired level. en en 3 Fig. 1 Control Panel Flap (Fast-Freeze compartment) Ice cube tray & Ice bank Drawers Air grille Adjustable front feet 1. 2. 3. 4. 5. 6. Warning Below information about accessories are supplied only for reference. Below accessories may not be exactly same as the accessories of your appliance. en en 1 = Lowest cooling setting (Warmest setting) 4 = Highest cooling setting (Coldest setting) (Or) Min. = Lowest cooling setting (Warmest setting) Max. = Highest cooling setting (Coldest setting) Please choose the setting according to the desired temperature. The interior temperature also depends on ambient temperature, the frequency with which the door is opened and the amount of foods kept inside. Frequently opening the door causes the interior temperature to rise. For this reason, it is recommended to close the door again as soon as possible after use. The normal storage temperature of your appliance should be -18 °C (0 °F). Lower temperatures can be obtained by adjusting the thermostat knob towards Position 4 (or Max.). We recommend checking the temperature with a thermometer to ensure that the storage compartments are kept to the desired temperature. Remember to take the reading immediately since the thermometer temperature will rise very rapidly after you remove it from the freezer. Setting the operating temperature (Fig. 2) The operating temperature is regulated by the temperature control. 4 Warm Cold 1 2 3 4 (Or) Min. (-18 °C) Max. (-24°C) Indicator lights There are three coloured indicator lights located inside the appliance which show the operating mode of the freezer (Fig. 2). Amber Indicator (1) Illuminates when the fast-freeze switch (4) is turned on and stays on for maximum 34 hours or until the fast freeze button is turned off. Fast-freeze operation is for freezing fresh food (see Freezing Fresh Food section). Green Indicator (2) Illuminates when the appliance is connected to the mains and will glow as long as there is electricity present. The green indicator does not give any indication of the temperature inside the freezer. Red Indicator (3) Illuminates a. When the internal temperature rises above -5 °C. (The light turns off when the temperature cools down to - 9 °C) b. If the appliance is overloaded with fresh food. c. If the appliance door is left open accidentally. Note: Red indicator light has a built-in delay. Once the appliance is energized red indicator light will not illuminate for 24 hours. Thermostat knob (5) The thermostat knob is located on the indicator light frame. Important: When you press the fast-freeze switch or adjust the set temperature, there may be a short delay before the compressor starts to operate. This is normal and not a compressor fault. - E0 blinks on display if there is a freezer sensor failure. - E1 blinks on display if there is a defrost s...