Stimmen - 2, Durchschnittliche Bewertung: 3.5 ( )

Hersteller: Invacare Dateigröße: 101.78 kb Dateiname: Unterrichtssprache:

If you are unable to understand the Warnings, Cautions, and Instructions, contact your Invacare dealer or Invacare Account Services at 1-800-333-6900 before attempting to install this equipment - otherwise, injury or damage may occur. Check ALL parts for shipping damage. In case of shipping damage, DO NOT use.Contact Carrier/Dealer for further instruction. Ensure that ALL parts are tight at all times. Make sure that the snap buttons protrude through the same respective adjustment hole of each leg extension and an even height adjustment is achieved. Ensure that the leg extensions are securely locked in place. Check suction cups for rips, tears, cracks or wear. If any of these conditions exist, replace suction cups immediately. For transfer bench use, the bathtub floor should be dry and free of dirt, oils etc. before using. Both suction cups MUST be in contact with tub floor at all times. Users with limited physical capabilities should be supervised or assisted when using the transfer bench. Follow ALL Warnings and/or Cautions applicable to the product the Leg Extensions are used with. ASSEMBLY OF THE LEG EXTENSIONS W/3-INCH SUCTION CUPS (FIGURE 1) 1. Screw the stem of the NEW suction cups into the NEW threaded leg inserts. Leg Extension Stem Suction Cup FIGURE 1 - ASSEMBLY OF THE LEG EXTENSIONS W/ 3-INCH SUCTION CUPS REMOVING THE EXISTING LEG EXTENSIONS (FIGURE 2) 1. Shower Chair: Depress the snap button and remove the existing leg extension. Repeat for all four (4) legs. 2. Transfer Bench: Depress the snap buttons and remove the existing leg extensions that are located on the side of the seat arm. NOTE: The following illustration represents the external leg extension found on the shower chair and/or the transfer bench. The internal leg extension, found on the Deluxe/Vinyl padded shower chair, removes in the same manner. Snap Button Leg Extension FIGURE 2 - REMOVING THE EXISTIING LEG EXTENSIONS 1 INSTALLING THE LEG EXTENSIONS W/3-INCH SUCTION CUPS WARNING Make sure that the snap buttons protrude through the same respective adjustment hole of each leg extension and an even height adjustment is achieved. Ensure that the leg extensions are securely locked in place. NOTE: Adjustability on the external leg extensions is obtained by the holes provided on the leg extension itself. Adjustability on the internal leg extensions is obtained by the holes provided on the legs of the Deluxe/ Vinyl padded shower chair. 1. Shower Chair: Install the NEW leg extensions w/3inch suction cups onto the existing shower chair where the four (4) existing legs were just removed. 2. Transfer Bench: Install the NEW leg extensions w/ 3-inch suction cups onto the Transfer Bench where the two (2) existing leg extensions were just removed. NOTE: Remember that some tub floors are higher than the bathroom floor. It may be necessary to make the leg extensions w/suction cups shorter than the legs on the bathroom floor to ensure theTransfer Bench sits level. USING THE LEG EXTENSIONS ...

Herunterladen

Geben Sie zwei Ziffern: