Login:
Stimmen - 1, Durchschnittliche Bewertung: 5 ( )

Anleitung First Alert, modell FE10G-M

Hersteller: First Alert
Dateigröße: 365.24 kb
Dateiname: 12fc26fc-4343-45e5-892d-98bd887ad650.pdf
Unterrichtssprache:en
Link zum kostenlosen Download Hinweise finden Sie am Ende der Seite



Anleitung Zusammenfassung


• On a clean, dry surface where the temperature does not go above 120° F (49° C) or below –40° F (–40° C). HOW TO INSTALL THIS EXTINGUISHER NOTE: Since wall surface types vary, mounting screws are not included. Purchase screws or bolts specifically designed for the surface on which you will mount the fire extinguisher. The fire extinguisher label lists its maximum weight. Mounting screw head type should be #8 pan on round head screws with #8 flat washers. INSTALL THE MOUNTING BRACKET ON A WALL 1. The extinguisher has a bracket for wall mounting. Install the mounting bracket on a wooden stud or other solid surface that will support the weight of the extinguisher using the screws or bolts you purchased (see "Note" above). 2. After installing the mounting bracket, replace the extinguisher on the bracket with the label facing outward, so the label can be easily read. Raise and wrap the bracket straps around the cylinder and snap the buckle closed. INSTALLING THE MOUNTING BRACKET IN A MARINE CRAFT (Excluding Model FE1A10G30) According to the NFPA Standard 302 (Fire protection Standard for Pleasure and Commercial Motor Craft): • On marine crafts, portable fire extinguishers shall be located to be readily accessible. Extinguishers shall be secured with a marine bracket to permit immediate release. • On marine crafts, extinguisher agent cylinders shall be mounted a minimum of 2 inches (5 cm) above moist or wet surfaces to reduce the danger of corrosion. CHECKING AND INSPECTING THE FIRE EXTINGUISHER 1. Inspect the extinguisher once a week. Remove the extinguisher from the mounting bracket and inspect the gauge. If the yellow pointer is in the GREEN area, the extinguisher is properly pressurized and ready to use. If the pointer drops into the RED area, the extinguisher has lost some pressure and should be replaced. 2. Check for signs of damage or misuse. Make sure you can still read all the text on the label. Carefully examine the surface of the extinguisher for corrosion. You can help prevent corrosion by cleaning the extinguisher if it gets wet or dirty. If you notice corrosion during the warranty period, return the unit to First Alert® (See "Limited Warranty" at the end of this manual). 3. Make sure the tamper indicator ("safety seal") is still intact and the nozzle is clean and unobstructed. 4. When you finish inspecting the extinguisher, always put it back securely into the mounting bracket. For more information about fire extinguishers, consult the NFPA Standard #10, "Portable Fire Extinguishers," available from the National Fire Protection Association, Inc., Batterymarch Park, Quincy, MA 02169, USA. • Do not mount the extinguisher on drywall or plaster without adequate support. Use strong screws or bolts to mount the bracket securely into solid wood or metal that can support it, like a wooden partition stud. Secure mounting is needed so you can remove the extinguisher quickly and easily in an emergency. Also, if the extinguisher is not held securely...

Dieses Handbuch ist für folgende Modelle:
Alarm - FE1A10G (365.24 kb)
Alarm - FE1A10G30 (365.24 kb)
Alarm - FE5G (365.24 kb)
Alarm - FE5G-M (365.24 kb)

Bewertungen



Bewerten
Vorname:
Geben Sie zwei Ziffern:
capcha





Kategorien