Stimmen - 4, Durchschnittliche Bewertung: 3.8
(
)
)
|
Anleitung Zusammenfassung
Exposure Times The carbon monoxide concentrations and time standards for the alarms are as follows: The Full Alarm Activates • Within 60–240 minutes at exposures of 70 ppm • Within 10–50 minutes at exposures of 150 ppm • Within 4–15 minutes at exposures of 400 ppm WARNING: O. Warranty Information 5 Year Limited Warranty Dicon Global Inc., which manufactures American Sensors Carbon Monoxide Alarms, warrants its product, to the original consumer purchaser, to be free from defects in material and workmanship under normal use and service for a period of five (5) years from date of purchase. Dicon Global Inc. makes no other express warranty for this Carbon Monoxide Alarm. No agent, representative, dealer or employee of the Company has the authority to increase or alter the obligations or limitations of this warranty. The company’s obligation of this warranty shall be limited to the repair or replacement of any part of the alarm which is found to be defective in materials or workmanship under normal use of service during the five (5) year period commencing with the date of purchase. The company shall not be obligated to repair or replace units which are found to be in need of repair because of damage, unreasonable use, modifications, or alterations occurring after the date of purchase. The duration of any implied warranty, including that of merchantability or fitness for any particular purpose, shall be limited to five (5) years on the Alarm commencing with the date of purchase. In no case shall the Company be liable for any consequential or incidental damages for breach of this or any other warranty, expressed or implied whatsoever, even if the loss or damage is caused by the Company’s negligence or fault. Some states/provinces do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights, which vary regionally. P. Tips for the Homeowner Energy Conservation and Indoor Air Quality Two steps that homeowners take to conserve energy may adversely affect indoor air quality. Since air leakage can account for as much as 40% of heat loss, houses are being made more air tight. Reduced air leakage will contribute to higher concentrations of air contaminants from indoor sources and can cause draft reversal in the furnace or fireplace chimney when the demand for air by fireplaces, furnaces and exhaust fans exceeds the air supplied by leakage area and supply ducts. Converting from oil to gas, without taking steps to prevent chimney deterioration, will increase the risk of chimney blockage, draft failure and the associated release of combustion products into the house. Qualified contractors and inspection by the gas company are recommended. Dirt and Blockage Never insulate or try to seal up a draft hood, wind cap or exhaust vent on any gas appliance (furnace, hot water heater, range, dryer or space heater). Keep your equipment area clean. Don’t store anything that could restrict air circulation close to equipment. It is absolutely essential to your safety that panels and grills on the furnace are kept in place and that the fan compartment door is closed when the furnace is operating. If you have a gas water heater, make sure that combustion air openings at the bottom of the tank and the opening below the draft diverter (on top of the tank next to the flue duct) remain unblocked. If you have a gas dryer, the exhaust duct must be vented to the outside and have a hood at the end. Check that the exhaust system is not blocked by lint or debris and that the flapper in the hood moves freely. For all fuel-burning equipment, make sure that vent hoods and pipes are not blocked by insulation, leaves or bird nests. Using other equipment that consumes or exhausts household air If you use exhaust fans, a fireplace or other fuel burning heaters or stoves: Run exhaust fans for just a minute or two at a time. Prolonged use could remove too much air, and it wastes heat. Do not run power attic vents during the winter or when your furnace is on. Important: Not suitable as a smoke alarm or for detecting other gases. This device is not suitable for installation in a hazardous location, as defined in the national electrical code. Units may be returned to point of purchase according to retailers exchange / return policy. Or call 1-800-387-4219, for shipping instructions and a returned goods authorization number “RGA” number, to return to Dicon Global Inc. Returned goods must be shipped prepaid. A cheque for $5.00 is also required for return postage. Please mark the “RGA” number on the exterior of your package. Date code located on back of smoke alarm. This product is intended for use in ordinary indoor locations of family living units. It is not designed to measure compliance with Occupational Safety and Health Administration (OSHA) commercial and industrial standards. Individuals with medica...
Dieses Handbuch ist für folgende Modelle:Alarm - CO900 (466.19 kb)
Alarm - CO920 (466.19 kb)