Stimmen - 3, Durchschnittliche Bewertung: 4
(
)
)
|
Anleitung Zusammenfassung
Contact authorized service personnel immediately. See below. Manual activation (Fire Drill or otherwise) Notification Appliance Circuits (NACs) can be activated by pressing and holding the DRILL button for at least two seconds. NOTE: You may want to disconnect the municipal box by sliding the DISCONNECT switch, located on the 4XTMF module, to its disconnect position (to the right). If a DACT is connected, notify the monitoring service before conducting any fire drills or tests. Alarm Silencing Notification Appliance Circuits may be silenced by pressing the ALARM SILENCE button. ALARM SILENCED will turn on yellow. Subsequent alarms will reactivate circuits. Press the RESET button to clear the "silenced" condition. NOTE: Notification Appliance Circuits may be programmed as nonsilenceable. Also, Signal Silence Inhibit, if enabled, will prevent silencing of NACs for one minute after an alarm (see manual). To test the indicators, LCD display and piezo Press and release the RESET button and check all indicators/ LEDs. Every indicator/LED should be on, LCD shows all pixels on, piezo sounder beeps. For more information, refer to the MS-5UD & MS-10UD Series Manual, Document #52626. It is kept in the following location: THIS SHEET SHALL BE FRAMED ADJACENT TO THECONTROLPANEL Document #52805 Rev. B 2/7/2011 ECN 10-008 @ Fire-uTe' ALarms by Honeywell In the event of trouble, contact the local Fire-Lite Service Representative Name:_ Company:_ Address:_ Telephone Number:_...
Dieses Handbuch ist für folgende Modelle:Alarm - MS-5UD (87.04 kb)