Anleitung GE, modell 165D4051G009
Hersteller: GE Dateigröße: 171.32 kb Dateiname: 06aaf649-1746-4e2c-bd8b-b8b781bbabdc.pdf
Unterrichtssprache:
|
|
|
|
Link zum kostenlosen Download Hinweise finden Sie am Ende der Seite
Anleitung Zusammenfassung
Do not operate dishwasher while changing springs or when toekick assembly is removed. BEFORE YOU BEGIN Read these instructions completely and carefully. IMPORTANT - Save these instructions for local inspector's use. IMPORTANT - Observe all governing codes and ordinances. Note to Installer - Be sure to leave these instructions with the Consumer. Note to Consumer - Keep these instructions with your Owner's Manual for future reference. imagination at work Step 1-Turn off power and water Step 6-Check door balance •Turn off power supply. ■Turn off water supply. • Lotch dishwasher door. Step 2-Move dishwasher • Remove the two screws securing the dishwasher to the countertop or side. • Pull the unit out from the cabinets approximately 10", until the door springs are exposed. Step 3- Remove toekick 1 Remove the screws on each side of the toekick face. ! Retain screws. ! Remove the toekick from the dishwasher and set aside. '' .. -• 1 1 I L“■1 Lj | ]_! ...................:........ Toekick Step 4-Remove old springs • Grasp the upper end of the spring attached to the dishwasher frame and release the hook. • Release opposite end of the spring from the tension cable and remove the spring. Step 5-Install new springs • Place the short end of the spring hook into the eyelet of the tension cable. • Stretch the long end of spring and hook into the lowest notch of the frame bracket. • Repeat the same procedure for the opposite side. insert \ Hook \ Over | Bracket / A WARNING: ■ All dishwashers can tip when removed from enclosure. > Injury to persons could result. > Use caution when opening door. • Check the door balance by opening and closing the door. « [f door drops open when released, increase spring tension, ff door closes when released, decrease tension. Note: Increase or decrease tension as shown. Adjust both springs to the same tension setting to correct balance. Tip: If door does not open easily or falls too quickly, check spring cable routing. The cable is held in place by "shoulders" on the pulley. Check to be sure cable has not ¡Correct slipped over the pulley shoulders and onto the axle. Incorrect Step 7-Reinstall toekick • Slide dishwasher back into opening. DO NOT PUSH AGAINST FRONT PANEL WITH KNEES. DAMAGE WILL OCCUR. • Reinstall the 2 screws securing the dishwasher to the countertop or sides and ensure door springs do not contact water line, fill hose, wiring, etc. • Turn water on. • Turn electrical power on. Correct Incorrect GE Consumer & Industrial General Electric Company Louisville, Kentucky 40225 ge.com Do Not Push Against Front Door Pane! With Knee. Damage to The Door Panel Will Occur. SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE Pub. No. 31-30593 DWG. NO. 206C1553P137 OSD-1297 5/05...