Stimmen - 2, Durchschnittliche Bewertung: 4
(
)
)
|
Anleitung Zusammenfassung
For residential installations in USA or Canada: If a product is defective in workmanship ormaterials and is removed and returned freight prepaid within three (3) years after the dateof the initial system installation, Goldline will, at its option, either repair or replace thedefective product and return it freight prepaid. For commercial installations, installations outside the USA and Canada, and accessoryproducts and replacement parts: If a product is defective in workmanship or materials andis removed and returned freight prepaid within one (1) year after the date of the initialsystem installation, Goldline will, at its option, either repair or replace the defectiveproduct and return it freight prepaid. Contact any Goldline dealer or contact Goldline at 61 Whitecap Drive, North Kingstown, RI 02852 for warranty service. The costs incurred in removal and/or reinstallation of theproduct are NOT covered under this warranty. Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you. WARRANTY EXCLUSIONS: 1. Material supplied or workmanship performed by others in process of installation. 2. Damage resulting from improper installation including installation on pools largerthan the product rating. 3. Problems resulting from failure to operate the product(s) in accordance with therecommended instructions contained in product’s owners manual(s). 4. Problems resulting from failure to maintain pool water chemistry in accordance withthe recommendations in the owners manual(s). 5. Problems resulting from tampering, accident, abuse, negligence, unauthorized repairsor alternations, fire, flood, lightning, freezing, external water, degradation of naturalstone used in or immediately adjacent to a pool or spa, war or acts of God. DISCLAIMER. THE EXPRESS LIMITED WARRANTY ABOVE CONSTITUTES THE ENTIRE WARRANTY OF GOLDLINE WITH RESPECT TO ITS POOL AUTOMATION AND CHLORINATION PRODUCTS AND IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE. IN NO EVENT SHALL GOLDLINE BE RESPONSIBLE FOR ANY CONSEQUENTIAL, SPECIAL OR INCIDENTAL DAMAGES OF ANY NATURE WHATSOEVER, INCLUDING, BUT NOT LIMITED TO, PERSONAL INJURY, PROPERTY DAMAGE, DAMAGE TO OR LOSS OF EQUIPMENT, LOST PROFITS OR REVENUE, COSTS OF RENTING REPLACEMENTS, AND OTHER ADDITIONAL EXPENSES, EVEN IFTHE SELLER HAD BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OF LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU. NO WHOLESALER, AGENT, DEALER, CONTRACTOR OR OTHER PERSON IS AUTHORIZED TO GIVE ANY WARRANTY ON BEHALF OF GOLDLINE. Installation Manual for model GVA-24 THIS WARRANTY IS VOID IF THE PRODUCT HAS BEEN ALTERED IN ANY WAY G LDLINE AFTER LEAVING THE FACTORY. CON TROLS 888-921-7665 Copyright © 2008 Goldine Controls 092051B IMPORTANT SAFETY INSTRUCTIONSIMPORTANT SAFETY INSTRUCTIONS 1 Maintenance The GVA-24 has two seals which should be lubricated every year. These O-ring sealsare located at the top and bottom of the actuator, where the shaft exits the actuatorhousing. The top O-ring requires the removal of the handle, and the bottom requiresthat the gear train is disengaged. Follow the procedure below for instructions on howto lubricate the O-ring seals. Before performing this procedure, turn off pool filtration. 1. Put the toggle switch in the OFF (center) position. 2. Remove the actuator from the valve. Remove the Locking Knob and handle. 3. Spread a small amount of Jacks 327 or other silicone based lubricant around theactuator shaft where it enters the cover. 4. Reinstall handle and Locking Knob but only tighten one (1) turn. 5. Push down on the Locking Knob to disengage the gear train. This will allow the handle and the shaft to be moved in any position. 6. Spread a small amount of lubricant around the actuator shaft where it protrudesfrom the bottom of the actuator enclosure. 7. Turn the handle once around to spread the lubricant. 8. Pull up on the handle, let it click into place and tighten Locking Knob. Troubleshooting If you believe your actuator is not operating properly or have questions regarding theoperation, call the Goldline Technical Service Dept. from Monday through Friday, 8AM to 8PM EST at 888-921-7665. 1. Actuator handle oscillates. This condition may happen when the GVA-24 O-ring seals are not lubricated sufficiently. See "Maintenance" section in this manual. 2. Actuator motor works but the valve diverter does not turn. On a pool/spa combination, the symptom of this problem would be a draining oroverflowing spa. This condition will occur if the actuator is in the manual position. To correct this, pull up on the handle while rotating the handle in any direction until itclicks, then tig...