Login:
Stimmen - 2, Durchschnittliche Bewertung: 4 ( )

Anleitung Avanti, modell LAVAPLATOS DWE1812W

Hersteller: Avanti
Dateigröße: 433.24 kb
Dateiname: beda4544-c384-4ac4-a452-6355028797d6.pdf
Unterrichtssprache:enes
Link zum kostenlosen Download Hinweise finden Sie am Ende der Seite



Anleitung Zusammenfassung


Pre-Wash Pre-Wash Wash Rinse Rinse Dry 125 NO Normal For normally soiled loads, such as pots, plates, glasses and lightly soiled pans. Pre-Wash Wash Rinse Rinse Dry 95 YES Light For lightly soiled loads, such as pots, plates, glasses and lightly soiled pans. Pre-Wash Wash Rinse Rinse Dry 85 NO Quick A shorter wash cycle for lightly soiled items that do not require drying Pre-Wash Wash Rinse Dry 65 NO 9 OVERFLOW PROTECTIONS Our Avanti dishwasher has an overfill protection device which could automatically shut off the inlet valve and start the drain pump if the water overflow. If this occurs, turn off the main water supply before calling a servicer. If there is water in the base pan because of an overfill or small leak, the water should be removed before restarting the dishwasher. DETERGENT DISPENSER The dispenser must be refilled before the start of each wash cycle according to the instructions provided in the “Wash Cycle Table”. Our dishwashers use less detergent rinse aid than conventional dishwashers. Generally, only one tablespoon of detergent is needed for a normal wash load. Also, more heavily soiled items need more detergent. Always add the detergent just before starting dishwasher, otherwise it could get damp and will not dissolve properly. 1. Main Wash Detergent 2. Prewash Detergent Compartment 3. Rinse-Aid Compartment 4. Rinse Aid Level Indicator Amount of Detergent to Use If the water isn’t too hard, you may also prevent the formation of deposits by adding detergent. The amount of detergent needed can vary due to differences in water hardness. To determine the water hardness in your area, contact your local water utility or area water softening company. The harder the water, the more detergent you may need. Remember, you should adjust the amount of detergent you use little by little until you find the correct amount. Removing Hard Water Spots From Dishes To remove hard water spots, try the following: Run dishes through a normal wash program. Remove all metal dishware, such as cutlery, pans, etc., from the dishwasher. Do not add detergent. Pour two cups of vinegar into a bowl and set the bowl face up on the lower rack of the dishwasher. Run the dishes through a normal wash program. If this doesn’t work, try the same process with . cup of citric acid crystals instead of vinegar. Proper Use Of Detergent Use only detergent specifically made for use in dishwasher. Keep your detergent fresh and dry. Don’t put powder detergent into the dispenser until you’re ready to wash dishes. Rinse Aid Dispenser The rinse aid is released during the final rinse to prevent water from forming droplets on your dishes that can leave spots and streaks. It also improves drying by allowing water to “sheet” off the dishes. Our dishwashers are designed to use liquid rinse aids. The rinse aid dispenser is located inside the door next to the detergent dispenser. To fill the dispenser, open the cap and pour the rinse aid into the dispenser until the level indicator turns completely black. The dispenser holds about 100 ml of liquid rinse aid. 10 Be careful not to overfill the dispenser, because this could cause over sudsing. Wipe away any spills with a damp cloth. Don’t forget to replace the cap before you close the dishwasher door. If you have soft water, you may not need rinse aid for it may cause a white film to develop on your dishes. Adjusting Rinse Aid Dispenser A measured amount of rinse aid is released during the final rinse. As with detergent, the amount of rinse aid needed for your dishes depends on the hardness of the water in your area. Too much rinse aid can result in lather of foaming and cause cloudiness or streaks on your dishes. If the water in you area is very soft, you may not need rinse aid. If you do, you can dilute the rinse aid with an equal amount of water. The rinse aid dispenser has 4 settings. Always start with the dispenser set on “1”. If spots and poor drying are problems, increase the amount of rinse aid dispensed by removing the dispenser lid and rotating the dial to “2”. IF the dishes still are not drying properly or are spotted, adjust the dial to the next higher number until your dishes are spot-free. We suggest you to set on”3”. When To Refill The Rinse Aid Dispenser If there is no rinse aid warning light on the control panel, you can judge the amount of rinse aid by the following means: The black dot on the rinse aid dispenser indicates the amount of rinse aid in the dispenser. As the rinse aid diminishes, the size of the black dot decreases. You should never let the rinse aid get below . full. How to Use the Upper Rack The upper rack is designed to hold more delicate and lighter dishware such as glasses, coffee and tea cup and saucers, as well as plates, small bowls and shallow pans ( as long as they are not too dirty). Position the dishes and cookware so that they do not get moved by the spray of waters. The upper rack can be adjusted for height by putting wheels of different height into the r...

Dieses Handbuch ist für folgende Modelle:
Geräte - LAVAPLATOS DWE1813B (433.24 kb)

Bewertungen



Bewerten
Vorname:
Geben Sie zwei Ziffern:
capcha





Kategorien