Stimmen - 1, Durchschnittliche Bewertung: 4
(
)
)
|
Anleitung Zusammenfassung
After you finish, please close the cover. See below: NOTE: DO NOT USE HAND DISH DETERGENT Using a detergent that is not specifically designed for dishwashers will cause the dishwasher to fill with suds. During operation, these suds will spill out of the dishwasher vents, covering the kitchen floor and making the floor wet. Because so many detergent containers look alike, store the dishwasher detergent in a separate space from all other cleaners. Show anyone who may use the dishwasher the correct detergent and where it is stored. While there will be no lasting damage to the dishwasher, your dishes will not get clean using a dishwashing detergent that is not formulated to work with dishwashers. Use Jet-Dry Rinse Agent Jet-Dry rinse agent removes spots and prevents new film buildup on your dishes, glasses, flatware, cookware and plastic. Filling the Dispenser The rinse agent dispenser holds 3.5 oz. of rinse agent. Under normal conditions, this will last approximately one month. Try to keep it full, but do not overfill. 1) Make sure the dishwasher door is fully open. 2) Turn the dispenser knob to the left and lift it out. 3) Add rinse agent until the indicator window looks full. 4) Clean up any spilled rinse agent with a damp cloth. 5) Replace the dispenser knob. Rinse Aid Setting The amount of rinse agent released into the final wash can be adjusted. The factory setting is at the midpoint. If there are rings of calcium (hard water) spots on dishes, try a higher setting. To adjust the setting Remove the dispenser knob; then turn the adjuster counterclockwise to increase the amount of rinse agent. Loading the Dishwasher Rack Position the dishes and cookware so that they will not get moved by the spray of water. To remove the plate bracket from the rack: Silverware Basket Silverware should be placed in the Silverware basket with handles at the bottom. If the rack has side baskets, the spoon should be loaded individually into the appropriate slots, especially long utensils should be placed in the horizontal position on the cup shelf. WARNING: Do not let any item extend through the bottom of the rack or cutlery basket. WARNING: Always load sharp utensils with the sharp point down! For personal safety and a top quality cleaning, place the silverware in the basket ensure the following: • They do not nest together. • Place silverware with handles-down. • But place knives and other potentially dangerous utensils handles-up. Forget to Add a Dish? You can load additional dishes / cutlery at any time before the detergent dispenser cup opens. 1 Press and hold the START / RESET button for approximately 3 seconds. (The START / RESET indicator light will be on indicating that the dishwasher is in PAUSE mode). 2 Slowly open the door to both stop the water spray arm and to release any steam if applicable. 3 Once the water spray arm has stopped, you can open the door completely. 4 Add the additional items to the wash rack. 5 Close the door 6 Press the START / Reset button again, the dishwasher will resume operation after 10 seconds. Care and Maintenance Instructions Filter system The filter system consists of a coarse filter, a flat (Main filter) And a micro filter (Fine filter). 1. Main filter: Food and soil particles trapped by this filter are pulverized by a special jet on the spray arm and washed down to drain. 2. Fine filter: This filter holds soil and food residue in the sump area and prevents it from being redeposit on the dishes during wash cycle. 3. coarse filter Larger items, such as pieces of bone or glass, that could block the drain are trapped in the coarse filter. To remove the items caught by the filter, gently squeeze the tap on the top of this filter and lift out. The filter efficiently removes food particles from the wash water, allowing it to be re-cycled during the cycle. For best performance and results, the filter assembly must be regularly. For this reason, it is a good idea to remove the larger food particles trapping in the filter after each wash cycle by rinsing the filter assembly under running water. To clean the coarse filter and the fine filter, use a soft cleaning brush. Reassemble the filter parts as shown in following and reinsert the entire assembly in the dishwasher, positioning in its seat and pressing downward. To remove the filter assembly, grab the handle of the fine filter, rotate it anti-clockwise then pull upward direction. Step1: rotate the fine filter anti-clockwise; Step2: lift it up; Step3: lift the Main filter up NOTE: If do it from step1 to step 3, the filter system will be removed; while if do it from Step 3 to Step 1, the filter system will be installed. Remarks: - Inspect the filters for blocking every time the dishwasher has been used. - By unscrewing the coarse filter. you can remove the filter system. Remove any food remnants and clean the filters under running water. WARNING: ·Never run the dishwasher without the filters in place. ·The dishwasher must never be used without t...
Dieses Handbuch ist für folgende Modelle:Geräte - DW6PS (1.02 mb)