|
Anleitung Zusammenfassung
-Carefully dispose of the packing material. -After removing the packing, check to make sure that the appliance is not damaged.If in doubt, contact a qualified professional. -The dishwasher must only be used by adults for the washing of household dishes and cooking utensils. -The appliance is not intended for use by young children or inform persons without supervision. -Young children should be supervised to ensure that they do not play with the appliance. -Keep detergents out of the reach of children, who must also be kept away from the dishwasher when it is open. -This appliance cannot be installed outdoors, not even if the area in which it is installed is covered by a roof; it is also very dangerous to leave it exposed to the rain and elements. -Do not touch the heating element during or after a wash cycle. Close-up View (Control Panel) -Do not lean or sit on the door when it is open as this could over turn the dishwasher. -If the appliance malfunctions, turn off water supply to the appliance and disconnect the plug from the wall socket. Then, consult the section entitled, "Troubleshooting." If you cannot solve the problem, contact a service centre. -Only specialised personnel are authorised to make repairs. -Appliances which are no longer being used must be made inoperable by cutting the power supply cord and removing the door lock. -If the supply cord is damaged, it must be replaced by the manu facture, its service agent of similarly qualified persons in order to avoid a hazard. -After installation, the power plug must be accessible. -Fundamental rules to follow when using the appliance: * Never touch the dishwasher when barefoot or with wet hands or feet; * We discourage the use of extension cords and multiple sockets; * During installation, the power supply cord must not be excessively or dangerously bent or flattened; * If the appliance is not operating properly or maintenance must be performed, disconnect the appliance from the power supply. To maintain the EFFICIENCY and SAFETY of this appliance,we recommend: -call only the Service Centers authorized by the manufacturer. -always use original Spare Parts A F E BC D G A B C D ON-OFF Light "Eco" Button Low Salt Indicator Light Half-load Button E F G ON-OFF Button Handle For Opening Door Knob For Selecting Cycle .1. GB Close-up View (Interior) Upper Rack Rack Height Adjustor Top Sprayer Arm Lower Rack A E Bottom Sprayer Arm B F Washing Filter C G Detergent and Rinse Aid Dispenser D Technical Characteristics Width 60 cm Depth 60 cm Height 85 cm Capacity 12 standard place settings Mains water pressure 0.03-0.6 MPa Power voltage 220-240V~ 50Hz Total absorber power 1950W GB .2. Salt Salt The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form on the dishes and utensils. The appliance is equipped with a special softener that uses a salt specifically designed to eliminate lime and minerals from the water. Loading the Salt into the Softener Always use salt intended for use with dishwashers. The salt container is located beneath the lower rack and should be filled as follows: -Remove the lower rack and then unscrew and remove the cap from the salt container; -If you are filling the container for the first time, fill it with water; -Place the end of the funnel (supplied) into the hole and introduce about 2 kg of salt. It is normal for a small amount of water to come out of the salt container. -Carefully screw the cap back on. Adjusting Salt Consumption The dishwasher is designed to allow for adjusting the amount of salt consumed based on the hardness of the water used. This is intended to optimise and customise the level of salt consumption so that it remains at a minimum. To adjust salt consumption, proceed as follows: -Unscrew the cap from the salt container; -There is a ring on the container with an arrow on it (see figure). -If necessary, rotate the ring in the anticlockwise direction from the "-" setting towards the "+" sign, based on the hardness of the water being used. It is recommended that adjustments be made in accordance with the following scheme: To prevent the formation of rust, load the salt just before beginning a wash cycle. Water Hardness Level Clarke degrees .dH mmol/l Selector position Salt consumption (Grams/cycle) Autonomy (cycles/2kg) 1 0 14 2 3 4 .3. GB Detergent and Rinse Aid Detergent Detergent specifically intended for use with dishwashers must be used. The dispenser must be refilled before the start of each wash cycle following the instructions provided in the "Wash Cycle Table." The detergent dispenser is located on the inside panel the door. Loading the detergent To open the "A" cover on the dispenser, press the "B" button. The detergent for the wash cycle should be poured into the "C" compartment. After the detergent has been placed in the dispenser, close the cover and press down until it clicks in place. B C A NOTE: To facilitate closing the cover, remove any excess deter...
Dieses Handbuch ist für folgende Modelle:Geräte - DW12-BFM (394.51 kb)