Stimmen - 0, Durchschnittliche Bewertung: 0 ( )

Hersteller: Bosch Dateigröße: 2.15 mb Dateiname: Unterrichtssprache:

Dieses Gerät hat auch andere Anweisungen:

Geräte - DF461162F/32 (2.13 mb)

Geräte - DF461162F/32 (2.21 mb)

Geräte - DF461162F/32 (2.29 mb)

3 Remove any residue and clean filters under running water. 4 Re-install filter system in reverse sequence and ensure that the arrow marks are opposite each other after closing the filter system. Spray arms Limescale and contaminants in the rinsing water may block nozzles and bearings on the spray arms 1: and 1Z. 1 Check outlet nozzles on the spray arms for blockages. 2 Unscrew the upper spray arm 1:. 3 Remove the lower spray arm 1Z upwards. 4 Clean spray arms under running water. 5 Re-engage or screw on spray arms. Fault, what to do? Fault, what to do? Experience has shown that you can rectify most faults which occur in daily operation yourself. This ensures that the machine is quickly available to you again. In the following overview you can find possible causes of malfunctions and helpful information for rectifying them. N o t e If the appliance stops during dishwashing or does not start for no obvious reason, first run the Abort programme function (Reset). (See chapter entitled “Operating the appliance”) a=Wa r n i ng Don’t forget: Repairs may be carried out by technicians only. If a component has to be replaced, ensure that only original spare parts are used. Improper repairs or use of non-original spare parts may cause considerable damage and put the user at considerable risk. Wa s te wa ter pump Large food remnants or foreign objects which were not captured by the filters may block the waste water pump. The rinsing water will then be above the filter. In this case: 1 First always disconnect the appliance from the power supply. 2 Take out top basket 1* and bottom basket 9*. 3 Remove the filters 1j. 4 Scoop out water, use a sponge if required. 5 Prise out the white pump cover (as illustrated) using a spoon. Grip the cover on the crosspiece and lift diagonally inwards. Remove cover completely. 6 Check impeller wheel and remove any foreign objects. 7 Place cover in the original position and press down until it engages (click). 8 Install filters. 9 Re-insert baskets. 2 3 F a ult, w ha t to d o ? Fault table Fault Cause Remedial action “Check water supply” Supply hose kinked. Install supply hose without kinks. display @ lights up. Tap turned of f. Turn on the tap. Tap jammed or calcified. Turn on the tap. Flow rate must be min. 10 l/min. when water supply is open. Filter in the water supply blocked. Switch off the appliance and pull out the mains plug. Turn off the tap. Unscrew water connection. Clean filter in the supply hose. Screw water connection on again. Check for leaks. Reconnect power supply. Switch on the appliance. Error code “:.. is lit. Filters 1j are soiled or blocked. Clean filters. (See Cleaning and maintenance) Error code “:.… is lit. Waste water hose is blocked or kinked. Install hose without kinks, remove any residue. Siphon connection still sealed. Check connection to siphon and open if required. Cover on the waste water pump loose. Lock cover correctly. (See Waste water pump) Error code “:.† is lit. Waste water pump blocked or cover Clean pump and lock cover correctly. (See on the waste water pump is not locked Waste water pump) in position. Error code “:.. is lit. Mains voltage too low. Not an appliance fault, have the mains voltage and electrical installation checked. A different error code is indicated A technical fault...

Herunterladen

Geben Sie zwei Ziffern: