Stimmen - 2, Durchschnittliche Bewertung: 3 ( )

Hersteller: AEG Dateigröße: 1.1 mb Dateiname: Unterrichtssprache:

This will release any accumulated hydrogen gas. As the gas is flammable, do not smoke or use an open flame during this time. l) Remove the door to the washing compartment when removing an old dishwasher from service or discarding it. SAVE THESE INSTRUCTIONS GROUNDING INSTRUCTIONS This appliance must be grounded. In the event of a malfunction or breakdown, grounding will reduce the risk of electric shock by providing a path of least resistance for electric current. This appliance is equipped with a cord having an equipment-grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is installed and grounded in accordance with all local codes and ordinances. WARNING – Improper connection of the equipment-grounding conductor can result in a risk of electric shock. Check with a qualified electrician or service representative if you are in doubt whether the appliance is properly grounded. Do not modify the plug provided with the appliance; if it will not fit the outlet, have a proper outlet installed by a qualified electrician. DISHWASHERINSTALLATION AND FITTING 1 UNPACKING THE DISHWASHER UNPACKAGING DISHWASHERINSTALLATION AND FITTING 1 UNPACKING THE DISHWASHER UNPACKAGING 2 PLUMBING IN 2 PLUMBING IN The dishwasher is equipped with a high pressure water connection pipe with a 3/4 (1.905 cm) directional internal pipe thread at normal temperature and pressure values (NPT). In order to make its installation easier, the dishwasher includes a 3/8” (0.9525 cm) brass compression part for 3/4 NPT which adapts the pipe connector to a 3/8” compression part which incorporates the majority of the valves which close the water connection for domestic dishwashers. Alternatively, the pipe can be coupled directly to a male 3/4 brass NPT connector which is available in most hardware stores. Adjust the direction of the pipe and the connection which comes out of the rear part of the appliance following the installation instructions. 3/8” Comp x 3/4” BSP Closing valve Washer Water connection pipe Closing valve 3/4" NPT Water connection pipe b1 b2 WARNING DRAINAGE Connect the drainage pipe incorporated into a waste disposal unit, on a drainage pipe tap or in a residual gap depending on plumbing standards in force. It is possible to lengthen the drain pipe with material resistant to hot water and detergent. Always keep an inner diameter of at least 5/8” (1.5875 cm). Never exceed the maximum distance of 9” (22.86 cm) to the drainage piping. Raise the drain pipe and fasten it to the lower part of the worktop. Lower it again to the drainage connection point following these instructions: 1. The connection with the drain pipe must be at least 10” (25.4 cm) from the floor. 2. The connection with the drain pipe must be no higher than 35” (88.9 cm) from the floor. In order to make installation easier, the dishwasher includes an assembly bracket for curved drain pipes. With an air gap Sink Min. 10" Sink Garbage disposal unit Min. 10" Without an...

Herunterladen

Geben Sie zwei Ziffern: