Stimmen - 4, Durchschnittliche Bewertung: 4.3 ( )

Hersteller: AEG Dateigröße: 575.75 kb Dateiname: Unterrichtssprache:

15 Remove the coarse strainer and clean It under running water with a brush. If food residues have become stuck, take out the insert (Fig. 16) and remove the food residues. Then replace the insert firmly In the coarse strainer and place it in the fine strainer. Fine filter Fig. 17 If necessary, also clean the fine strainer and microfilter. Twist it to the left and clean the upper and lower sides. Unscrew it anticlockwise and clean the top and the underside of the strainer. Then replace it so that the outside edge rests correctly on the floor of the machine (i.e. forms a tight fit). Then screw on tight in a clockwise direction. Never carry out a washing programme without a strainer. Care instructions Never clean the screens and controls of your If cleaning is necessary, use only lukewarm appliance with commercially available water, furniture cleaners and aggressive detergents. If you think your dishwasher is not working properly Before calling our service centre, please check whether you can rectify the fault yourself by following the instructions given below. What should I check if....? ... the program will not start? • Are the fuses in order? • Have you closed the door properly? ... no water flows in? • Have you turned on the water tap? • Check the water supply hose (it must not be kinked). ... the programme switch stops at the start of cleaning (symbol HIT ) or rinsing with rinse aid (symbol )? • Have you fully opened the water tap (see page 13)? • Check the strainer at the screwed connection of the supply hose (please clean if dirty). • Is a minimum water pressure of around 1 bar available (see page 20)? the crockery is not clean? Did you select the correct programme? Remember to use a programme suitable for the nature and degree of soiling of your crockery. Did you arrange the crockery in accordance with the instructions given In this manual? The sprayed water must have access to all surfaces, both internal and external. The baskets must not be overfilled! • Have the spray arms been obstructed by a piece of crockery or cutlery? Please make sure that, for better drainage of residual water at the programme end, the upper spray arm obliquely tilts when it comes to rest. When operational, it automatically runs in the horizontal position. 16 If you think your dishwasher is not working properly • Are the strainers clean? Did you replace the strainers properly after cleaning them? • Have you used sufficient detergent? • Check the drain hose (it must be run according to the instructions given on pages 20/21). • In the event of a hot-water connection (up to max. 60 °C) — to ensure good economy, only recommended if a cheap supply of hot water is available — use no 50° programmes so that the detergent has a sufficiently long time to act. ... the dishes do not dry and haVe no sparkle? • Have you used a branded rinse aid? • Is there enough rinse aid in the dispenser? (check rinse aid indicator on dosage combination). • Was the correct dosage selected? In case of an overdosage: If streaks, stripes, and milky shapeless marks (also blue-coloured blooms) form on the crockery, too much rinse aid is being added. Therefore decrease the dose! rust marks can be seen inside the machine? The machine interior, filters, and door interior are made of stainless steel and will not rust. If rust is found on these parts, this must be from another source (rust in water, rust particles from water pipes, saucepans, and cutlery). Remove the marks with a commercially available stainless steel cleaner. ... the drain pump runs continuously (even when the machine is stopped)? • The water protection system (see page 21) has responded. First close the water tap and then unplug the machine. • In this case, the service centre should always be called for fault-finding. In case of an underdosage: If dried water droplets (also greyish white drop edges) form, especially on glasses, too little rinse aid is being added. Therefore increase the dose! 17 After-sales service On page 16/17, we have listed the most important faults which you can remedy yourself. • If you nevertheless wish to call in our service engineer to eliminate one of the above faults or a fault resulting from incorrect operation, we should like to draw your attention to the fact that repairs are not carried out free of charge even during the warranty period. • You are therefore strongly advised to adhere to the instructions given in this manual and also to follow our additional tips and recommendations. • If you find that this instruction manual cannot help you in detecting and eliminating a particular fault, then please call the service centre. Our electrical appliances comply with the valid safety requirements. Repairs to electrical appliances should only be performed by a trained electrician. Improper repairs may place the user at serious risk. When calling the service centre, please state the E-number (product number) a...

Herunterladen

Geben Sie zwei Ziffern: