Stimmen - 2, Durchschnittliche Bewertung: 3.5
(
)
)
|
Anleitung Zusammenfassung
HEAVY 6.2 gallons, 125 minutes This cycle is meant for heavily soiled dishes or cookware with dried-on or baked-on soils. This cycle may not remove burned-on foods. Everyday dishes are safe to be used in this cycle. This cycle also includes heated dry. NORMAL 5.3 gallons, 100 minutes This cycle is meant for loads of everyday dishes, glasses and cookware with medium soils that have not been pre-rinsed. This cycle also includes heated dry. LIGHT 4.4 gallons, 85 minutes This cycle is meant for loads of everyday dishes, glasses and cookware with light soils that have been pre-rinsed. This cycle also includes heated dry. GLASSES 3.5 gallons, 65 minutes This cycle is meant for lightly soiled glassware. This cycle has less heating during the wash and rinse to protect your glassware. This cycle also has a lower temperature heated dry. AIR-DRY 3.5 gallons, 50 minutes This cycle is meant for loads of everyday dishes, glasses and cookware with light soils that have been pre-rinsed and should air dry naturally. This cycle does not include heated dry. SPEED 5.3 gallons, 80 minutes This cycle is meant for loads of everyday dishes, glasses and cookware with medium soils that have not been pre-rinsed. This cycle features reduced wash times to allow for faster cycle completion. This cycle also has a reduced time heated dry. RINSE 1 gallon, 10 minutes For rinsing partial loads that will be washed later. Do not use detergent with this cycle. This cycle does not include heated dry. Control Panel Dishwasher 3 DELAY HOUR This option allows you to delay the start of a wash cycle for up to 24 hours. SELECTION With the door open, turn the dishwasher ON by pressing the ON/OFF button; then press DELAY HOURS button to choose the number of hours you want to delay the start of the wash cycle. The hours will show in the display window. NOTE: To cancel the DELAY HOURS option before the start of the cycle, repeatedly press the DELAY HOURS button until the display is blank or reads “00.” 4 5 STARTING After selecting the wash cycle (Step 2) and delay hours (Step 3), if desired, close the door of the A CYCLE dishwasher to start the cycle or begin the DELAY HOURS countdown. When the cycle starts, the drain begins and approximately 60 seconds later the water fill begins. STATUS INDICATORS LOW RINSE AID The red light will display when the rinse aid dispenser needs to be refilled with liquid rinse aid. Use of Jet-Dry® or Cascade Crystal Clear® rinse agent removes spots and prevents new film buildup on your dishes, glassware, flatware, cookware and plastics. See page 6 for instructions on refilling the rinse aid dispenser. CLEAN The green light will display and a beep will sound to alert you that the wash cycle is complete. Using the Dishwasher Dishwasher The entering water should be at least 120°F Turn on the hot water faucet nearest the Check and not more than 150°F for effective cleaning dishwasher, place the thermometer in a glass and the Water and to prevent dish damage. Check the water let the water run continuously into the glass until Temperature temperature with a candy or meat thermometer. the temperature stops rising. A rinse agent improves dry performance, Use a reduces spots and prevents new film buildup Rinse on your dishes, glasses, flatware, cookware Agent and plastic. Jet-Dry® and Cascade Crystal Clear® are recommended rinse agents for Monogram Dishwashers. Filling the Dispenser The rinse agent dispenser holds 3.5 oz. of rinse agent. Under normal conditions, this will last approximately one month. Try to keep it full, but do not overfill. 1. Make sure the dishwasher door is fully open. 2. Turn the dispenser cap to the left and lift it out. 3. Add rinse agent until the indicator window looks full. 4. Clean up any spilled rinse agent with a damp cloth. 5. Replace the dispenser cap. Rinse Aid Setting The amount of rinse agent released into the final wash can be adjusted. The factory setting is at the midpoint. If there are rings of calcium (hard water) spots on dishes, try a higher setting. If you observe foam in the final rinse, try a lower setting. To adjust the setting, remove the dispenser knob; then turn the adjuster counterclockwise to increase the amount of rinse agent or clockwise to reduce the amount of rinse agent dispensed. Indicator Min Max Dispenser cap Adjustable setting • No prerinsing of normal food soil is required if using • Remove large quantities of any remaining food. Dish Preparation Heavy, Normal or Speed wash cycles. • Remove leafy vegetables, meat, trimmings and • Scrape off hard soils, bones, toothpicks, skins and seeds. excessive amounts of grease or oil. Prior to Loading Use only detergent specifically made for use in dishwashers. Cascade® and Electrasol® Automatic Dishwashing Detergents have been approved for use in all Monogram Dishwashers. Keep your detergent fresh and dry. Don’t put detergent into the dispenser until you’re ready to wash dishes. The amount of detergent to use depends on whether your wa...
Dieses Handbuch ist für folgende Modelle:Geräte - ZBD1850 (820.84 kb)