Stimmen - 1, Durchschnittliche Bewertung: 3 ( )

Hersteller: GE Monogram Dateigröße: 1.18 mb Dateiname: Unterrichtssprache:

Check the Water Temperature The entering water should be at least 120°F and not faucet nearest the dishwasher, place the thermometer more than 150°F, for effective cleaning and to prevent in a glass and let the water run continuously into the dish damage. Check the water temperature with a glass until the temperature stops rising. candy or meat thermometer. Turn on the hot water Use Jet-Dry® or Cascade Crystal Clear® Rinse Agent Jet-Dry® or Cascade Crystal Clear® rinse agents remove spots and prevent new film buildup on your dishes, glasses, flatware, cookware and plastic. Filling the Dispenser The rinse agent dispenser holds 3.5 oz. of rinse agent. Under normal Indicator conditions, this will last approximately one month. Refill when rinse agent is not visible in the indicator. Do not overfill. 1 Make sure the dishwasher door is fully open. 2 Turn the dispenser cap to the left and lift it out. 3 Add rinse agent until the indicator window looks full. Do not overfill. Adjustable setting dial Min Max 4 Clean up any spilled rinse agent with a damp cloth to prevent Dispenser cap foam. 5 Replace the dispenser cap. Rinse Aid Setting The amount of rinse agent released into the final wash can be adjusted. The factory setting is at the midpoint. If there are rings of calcium (hard water) spots on dishes, try a higher setting. If you observe foam in the final rinse, try a lower setting. To adjust the setting Remove the dispenser cap, then turn the adjustable setting dial counterclockwise to increase the amount of rinse agent or clockwise to reduce the amount of rinse agent dispensed. Dish Preparation Prior to Loading No pre-rinsing of normal food soil is Remove leafy vegetables, meat trimmings, required. and excessive amounts of grease or oil. Scrape off hard soils, including bones, Remove acidic food soils that can discolor toothpicks, skins and seeds. stainless steel. Remove large quantities of any remaining food. 8 Use only detergent specifically made for use in dishwashers. Cascade® and Electrasol® Automatic Dishwashing Detergents have been approved for use in all GE dishwashers. Keep your detergent fresh and dry. Don’t put powder detergent into the dispenser until you’re ready to wash dishes. The amount of detergent to use depends on whether your water is hard or soft. With hard water, you need extra detergent. With soft water, you need less detergent. Protect your dishes and dishwasher by contacting your water department and asking how hard your water is. Twelve or more grains is extremely hard water. A water softener is recommended. Without it, lime can build up in the water valve, which could stick while open and cause flooding. Too much detergent with soft water can cause a permanent cloudiness of glassware, called etching. Use the information in the table below as a guideline to determine the amount of automatic dishwasher detergent to place in the dispenser. For heavily-soiled loads, use the Pots and Pans or Heavy Wash cycle and add a little extra detergent. DO NOT USE HAND DISH DETERGENT NOTE: Using a detergent that is not specifically designed for dishwashers will cause the dishwasher to fill with suds. During operation, these suds will spill out of the dishwasher vents, covering the kitchen floor and making the floor wet. Because so many detergent containers look alike, store the dishwasher detergent in a separate space from all other cleaners. Show anyone who may use the dishwasher the correct detergent and where it is stored. While there will be no lasting damage to the dishwasher, your dishes will not get clean using a ...

Herunterladen

Geben Sie zwei Ziffern: