8/91 42" SNOW PLOW/DOZER BLADE Mfg. No. 1691520 HITCH ASSEMBLY Mfg. No. 1692039 Contents SAFETY RULES ........................................................................... 2 PARTS ILLUSTRATION .................................................................... 3 ASSEMBLY, INSTALLATION & REMOVAL .................................................. 4 OPERATION AND NORMAL CARE ............................................. ........... 5 ADJUSTMENTS ......................................

26 PIN, Clevis, 3/8 x 4" 2 27 BUCKET, Material, 38" or 48" wide 1 ASSEMBLY INSTRUCTIONS NOTE: Leave all attaching hardware loose until the loader is completely assembled to facilitate assembly and ; proper loader alignment. INSTALLING LOADER SIDE FRAMES 1. Place 5/8 x 3-1/4 pins (21) into the hole in side frame mounting hooks (23). Fasten hooks (23) to side frames (12 & 13) with 1/2 x 3/4 serrated head cap screws (20), but do not tighten. 2. Position hinges (17) inside of side frames. Inst

NO'S. 1691309 1691310 1691311 1691312 1691313 “CONTENTS Page SAFETY DECALS...............................................................3 SAFETY PRECAUTIONS........................................................4 INTRODUCTION................................................................5 SPECIFICATIONS.............................................................. .6 OPERATION................................................................ .7-11 Preparing Tractor .................

The pump housing and gears are not sold as separate repair items, because the gears must be factory fit to the pump housing. If the pump should malfunction during the warranty period, return the complete pump assembly, without disassembling, to your authorized service department or contact your authorized service department for instructions. Unauthorized disassembly of the pump in the warranty period will VOID WARRANTY. The following is an outline of the procedures for disassembling and reassem

Install bolts, washers and nuts and torque to 75-100 ft.-lbs. F-2486-10-86 13 Regular maintenance of the loader hydraulic system will insure maximum loader efficiency and long life. A WARNING: NEVER perform maintenance beneath a raised loader. DAILY MAINTENANCE • Check level of hydraulic oil in loader left side frame reservoir before starting each day’s operation. If necessary, add oil to bring the oil level up to the level plug at the rear of side frame. Use a good quality AW# 15 hydraul

41° (E) Reach With Attachment On Ground (Average)................................ 425 in. (1080 mm) (F) Attachment Rollback Angle........................................ 16° (G) Digging Depth........................................... 3 in. (76 mm) (H)Overall Height In Carry Position..................... 40.75 in. (1035 mm) (Specifications and design subject to change without notice.) GENERAL TORQUE SPECIFICATIONS USE THE FOLLOWING TORQUES WHEN SPECIAL TORQUES ARE NOT GIVEN NOTE: These v