Stimmen - 2, Durchschnittliche Bewertung: 5 ( )

Hersteller: Amerec Dateigröße: 175.16 kb Dateiname: Unterrichtssprache:

You can close the unnecessary hole using the |r^ closing trap supplied. Included with the delivery, you will also receive a 2,00mm connecting pipe for connecting the stove to the smoke flue through the back hole. When connecting the stove to the smoke flue through the hole on top of the stove, we recommend you use our connecting pipes which are available as accessories- When doing this, do not forget to dose the smoke hole behind the stove using the closing trap supplied. (Figure 8) Do not install the connecting pipe too deep i nto the smoke flue, because c this would block the draught The gap between the smoke flue and the connecting pipe must be filled using e g, mineral wool. When installing the stove, make sure the stove stands firmly on its base and Li* the proper safety distances mentioned in these instructions have been observed PREHEATING In the factory, the interior parts of the stove have been coated with protective agents to prevent corrosion during storage. Before starting to use the stove and placing rocks on tho stove, you should preheat the stove in order to remove these protective agents. It is enough to burn 1-2 ovenfulls of wood for preheating. During preheating, sufficient ventilation should be arranged in the washroom to dissipate the smoke gases produced by the protective agents. STOVE ROCKS Always use rocks supplied by the manufacturer in your stove Before placing the rocks onto the stove, carefully wash them with clean water, Do not use any detergents. Place the rocks on top of each other so that they are level with the edge of the rock well. Be careful not to place the rocks too close to each other to allow air circulation between the rocks. Place the largest rocks at the bottom of the rock well. HEATING UP TH£ STOVE Only wood can be used for heating up the stove. Before heating, the stove grate should always be cleaned and the ash pan emptied Avoid heating the stove so that the passage in the rock well remains red heated for a long time beacause this would overload the firebox and shorten the lifetime of the stove. After your saunabath, you can leave a small fire In the stove to dry up the washroom constructions, STOVE MAINTENANCE The stove must be swep through the soot hatches at least once a year in order to maintain optimal draught- At the same time, it is also useful to check the condition of the stove rocks and to replace the decayed ones by new ones Prefer right or (eft handed-lnsiructicns how to make (he change 1. Remove the ash box door, 2. Remove ninge pin. A Hold on to the door and lift the hinge pin upwards to enable the lower part to com© free from the hofes of the door. B. Pull outwards. C. Pulldown. In order to make your Job easier, please hold on to the hinge pin by using pointed pliers. A. Hold on to the door. Push the hinge pin from the inside through the console and through the upper hole of the door. B. Push the hinge pin inwards. C. Push the hinge pin through the console and the ...

Herunterladen

Geben Sie zwei Ziffern: