Stimmen - 2, Durchschnittliche Bewertung: 4.5
(
)
)
|
Anleitung Zusammenfassung
• A small amount of power is always consumed even while on standby. CAUTION • Only use JVC power cord provided for this unit to avoid malfunction or damage to the unit. • Remove batteries when using the power cord. • Be sure to unplug the power cord from the outlet when going out or when the unit is not in use for an extended period of time. NOTE • The power will not be supplied through the batteries when the power is supplied through the AC IN jack on the unit. • The battery is consumed more quickly than usual when operating the unit continuously or operating it in a cold place. CAUTION To avoid battery leakage or explosion, handle batteries properly. • If you are not going to use this unit for a month or more, remove the batteries from the battery compartment. • Dispose of batteries in the proper manner, according to federal, state, and local regulations. • Do not mix with batteries of different types or with new and old ones. • Do not attempt to charge any batteries other than rechargeable ones. • Discard leaky batteries immediately. Battery leakage can cause skin burns or other personal injuries. • If chemicals leak onto the unit, clean the unit completely. • Battery shall not be exposed to excessive heat such as sunshine, fire or the like. CD player CD capacity: 1CD Signal-to-noise ratio: 60 dB Dynamic range: 60 dB Tuner FM tuning range: 88 MHz – 108 MHz AM tuning range: 530 kHz – 1 700 kHz Antennas: Telescopic antenna for FM Ferrite core antenna for AM General Speakers: 9 cm (3-9/16 in) cone x 2 Speaker impedance: 4 . Output power: 1.5 W per channel, min. RMS, driven into 4 . at 1 kHz with no more than 10% total harmonic distortions Input terminal: AUDIO IN (. 3.5) x 1 Power supply: AC 120 V , 60 Hz DC 9 V (R14(SUM-2)/C(14D) -size batteries x 6) Power consumption: 10 W (at operation) 1 W or less (on standby) Dimensions (W/H/D): 306 mm x 238 mm x 140 mm (12-1/16 in . 9-3/8 in . 5-9/16 in) Mass: Approx. 1.7 kg (3.8 lbs) (without batteries) Accessories provided: Power cord x 1 Design and specifications are subject to change without notice. Battery compartment R14(SUM-2)/C(14D) (not supplied) SPECIFICATIONS REFERENCES Handling discs • Remove the disc from its case by holding it at the edge while pressing the center hole lightly. • Do not scratch or touch the reflective recorded surface. • Do not stick or write anything on the label side. • Do not bend discs. • Avoid exposure to direct sunlight, extreme temperature or moisture. • When cleaning the disc, wipe it with a soft cloth in a straight line from center to edge. DO NOT use thinner, benzine, record cleaner or antistatic spray. To get the best performance from the unit, keep your discs and mechanism clean. Cleaning the unit • Disconnect the power cord before cleaning. • Wipe off stains with a soft cloth. If the unit is heavily stained, wipe it with a cloth soaked in waterdiluted neutral detergent and wrung well, then wipe clean with a dry cloth. • Since the unit may deteriorate in quality, become damaged or get its paint peeled off, be careful about the following: – DO NOT wipe it with a hard cloth. – DO NOT wipe it forcefully. – DO NOT wipe it with thinner or benzine. – DO NOT apply any volatile substances such as insecticides to it. – DO NOT allow any rubber or plastic to remain in contact for a long time. Lens Power cord (supplied) AC outlet Care and maintenance If you have a problem with this unit, check this list for a possible solution before calling for service. General Power does not come on. \ No power is supplied. Check the power cord connection or battery power. Playback sound is at a very low level. \ When power is supplied with batteries: Batteries are run down. Replace the batteries with new ones. No sound is heard. \ The volume is set to minimum. Radio operations Hard to listen to broadcasts because of noise. \ Direction of the antenna is inappropriate. Adjust the antenna correctly. Troubleshooting Inserting batteries Playable discs Connecting the power cord Disc operations The disc does not play. \ The FUNCTION selector is not set to CD. \ The disc is placed upside down. Place the disc with the label side facing up. \ The disc or the lens is dirty. Clean the disc or the lens. \ There is moisture condensation. Turn the unit on and wait a few hours before use. The sound is discontinuous. \ The disc is scratched or dirty. Other equipment operations The sound from the other equipment cannot be heard. \ The FUNCTION selector is not set to AUDIO IN. \ Check the connection. Blower Cleaning the CD pickup lens Keep the CD pickup lens clean, or the sound may be degraded. Use a blower (available at a camera store, etc.) to blow dust off the lens. Program playback 3 Set the source to AUDIO IN. 4 Start playing the equipment. 5 Adjust the volume. Up to 20 tracks can be programmed to play in a desired order. To program the playing order While playback is stopped... 1 Show the program creation display. • Now you can select the first track of the progra...