Stimmen - 2, Durchschnittliche Bewertung: 4
(
)
)
|
Anleitung Zusammenfassung
• Keep the unit away from a TV. Do not place the unit near a TV or avoid using the unit when the TV is turned on; otherwise the TV picture could be distorted. • Carrying handle – Do not raise or lower the carrying handle with the telescopic antenna extended, to avoid damage to the antenna. – Position the carrying handle so that it does not interfere with operation. 1 POWER SUPPLY English Operation on household AC 1 Connect the supplied AC power cord to the AC IN O jack on the rear panel of the unit. 2 Plug the AC power cord into an AC power outlet. Cautions • Use only the JVC power cord provided with this unit to avoid malfunction or damage to the unit. • Even when you turn off the unit by pressing the STANDBY/ON button, a very small current continues to flow. To save power and for safety when not using the unit for an extended period of time, disconnect the power cord from the household AC outlet. Operation on batteries Installing batteries 1 Open the battery compartment cover by pressing down the two tabs. 2 Install eight R20P (SUM-1)/D (13F) batteries. Insert the batteries with . and · positioned correctly referring to the drawing above the battery compartment. 3 Replace the cover. Battery replacement When the tape speed or output sound level decreases, or CD playback becomes intermittent, replace all batteries with fresh ones. For better battery usage •When making an important recording, use of new batteries (preferably alkaline batteries with a longer service life) is recommended to avoid any possible failure. • To prevent the power from being accidentally turned on, remove the batteries when carrying the unit by hand or in the trunk of a car, thus avoiding wasteful battery consumption. • Continuous operation of the unit causes the battery power to be consumed quicker than non-continuous operation. • Operation of the unit in a cold place causes the battery power to be consumed more quickly than in a warm place. Cautions If batteries are used incorrectly, it may result in electrolyte leakage or they may explode. • Make sure that the batteries are installed with the positive . and negative · terminals positioned correctly. • Do not mix new and old batteries together, or mix different types of batteries. • Do not try to recharge non-rechargeable batteries. • Remove the batteries when the unit is not to be used for an extended period of time. • Remove the batteries when operating the unit on the household AC; though the power supply is automatically switched from the batteries to the household AC when the AC power cord is connected. • If chemicals leaking from batteries come in contact with your skin, wash them off immediately with water. If chemicals leak on the surface of the unit, clean the unit completely. 2 English NAMES OF PARTS AND CONTROLS Top 1 2 3 4 5 67 8 9 101112 1 JOG VOLUME control 2 Disc compartment 3 0 PUSH 4 PROGRAM button 5 PRESET/REPEAT button 6 STANDBY/ON button 7 PRESET EQ button 8 HYPER-BASS SOUND button 9 Cassette operation buttons 8 PAUSE button § STOP/EJECT button 1 FF button . REW button 2 PLAY button ¶ REC button 10 FM MODE/BEAT CUT button 11 TUNER button 12 TAPE button Front STANDBY SEARCH UP SEARCH DOWN REMOTE SENSOR PLAY/PAUSE STOP RANDOM INTRO RC-ST3 CD PORTABLE SYSTEM 13 14 15 16 17 18 19 20 21 13 . SEARCH UP and 4 SEARCH DOWN 17 3/8 PLAY/PAUSE button buttons 18 RANDOM button 14 STANDBY indicator 19 Cassette holder 15 Display window 20 INTRO button 16 REMOTE SENSOR 21 7 STOP button 3 Rear 22 2324 English AC IN~ PHONES RESET 25 26 22 RESET key 25 Battery compartment 23 FM telescopic antenna 26 AC IN O jack 24 PHONES jack REMOTE CONTROL UNIT TUNER TAPE CD PROGRAM FM MODE HBS EQ RANDOM INTRO VOL PRESET/ REPEAT 1 button 1 8 2 TUNER button 93 4 and . buttons 2 4 PRESET/REPEAT button 3 10 5 RANDOM button 4 11 6 FM MODE button 5 12 7 Sound control buttons 6 HBS button 7 13 EQ button 8 TAPE button 9 CD 3/8 button 10 7 button 11 PROGRAM button 12 INTRO button 13 VOL 5 and VOL . buttons 4 English Installing batteries 1 Remove the battery compartment cover. 2 Insert two R03 (UM4)/AAA (24F) batteries. Insert the ·ends first. Make sure that the .and · terminals are positioned correctly. R03 (UM4)/AAA (24F) battery 12 1 3 Replace the cover. Battery replacement The maximum operating distance between the remote control unit and the REMOTE SENSOR section on the main unit is approximately 7 meters. When this operating range decreases or operations with the remote control unit become unstable, replace both batteries with new ones. Notes on using the remote control unit • Point the top of the remote control unit toward the REMOTE SENSOR section as directly as possible. The distance operable from the main unit decreases if you point the remote control unit at an angle. • Do not expose the REMOTE SENSOR section to strong lighting or direct sunlight. • Make sure that there are no obstacles between the remote control unit and the REMOTE SENSOR section. 5 TURNING THE UNIT ON AND OFF STANDBY/ON Engli...
Dieses Handbuch ist für folgende Modelle:Player - LVT1000-004A (2.66 mb)