Stimmen - 2, Durchschnittliche Bewertung: 3
(
)
)
|
Anleitung Zusammenfassung
If the unit was shipped to you directly, notify your shipper immediately. Kenwood recommends that you retain the original carton and packing materials in case you need to move or ship the unit in the future. Keep this manual handy for future reference. DPC-X337 (EN) Part names Unit Display AD.A.S.C.(Digital Anti Shock Circuit) key .P.MODE (Play mode) key CPROGRAM key IDisplay ‰SKIP/SEARCH 4, . (Skip/Search) keys Battery duration indicator Repeat mode indicator Program mode indicator Playng time display Track number display C.. I I . I A ‰ O ¬..O . O.. . ... o.. IPLAY/PAUSE 38 (Play/Pause) key ISTOP 7 (Stop/Off) key OOPEN switch (Slide to open top cover) ¬HOLD switch OB.BOOST (Bass Boost) key .VOLUME control knob Ramdom mode indicator Intoro scan indicator D.A.S.C. mode indicator What seems to be a serious trouble may sometimes be due to a simple mistake. Before calling for service, check the items shown in the following table again. (If you request servicing due to the reasons shown in the table, the service may be charged in some cases.) In case of difficulty Pressing a key cannot initiate an operation or turn the unit on. No sound is heard from the headphones. Sound skips, or is interrupted. Noise interferes. Rechargeable batteries cannot be recharged. . The HOLD switch is set to on (HOLD On). . The batteries are exhausted. . The disc is placed upside down. . Condensation has occurred inside the unit. . The AC adaptor is disconnected. . The headphones are connected incompletely. . The headphones are connected to LINE OUT jack . The volume is set to the minimum position on the unit. . The D.A.S.C. is set to off. . A strong vibration that exceeds the capacity of the D.A.S.C. has occurred. . The disc is dirty. . The lens is dirty. . The headphone plug is dirty. . The batteries are low. . The headphone plug is dirty. . The batteries are low. . The headphones are connected incompletely. . A source of strong magnetism or radio wave, such as a TV set or cellular phone, is present near the unit. . Commercially available rechargeable batteries are used. . Set the switch to off (HOLD Off). . Replace the two alkaline batteries, or recharge the rechargeable batteries. . Place the disc with the labeled side up. . Leave the unit for about 1 hour before re-use. . Connect it properly. . Insert the plug securely into the PHONES jack. . Insert the plug securely into the PHONES jack. . Adjust the volume on the unit. . The D.A.S.C. is set to on. . Place the unit in a place not subject to vibration. . Clean it. . The lens should be cleaned using a commercially available camera lens blower. . Clean it. . Replace or recharge the batteries. . Clean it. . Replace or recharge the batteries. . Insert the plug securely into the PHONES jack. . Install the unit away from a TV set, cellular phone, etc. . Use the exclusive rechargeable batteries (NB-3A70). Symptom Sound skip guard function (D.A.S.C.) When the D.A.S.C. function is operating, about a 180 seconds portion of signals is always stored in memory. Consequently, when the unit receives an impact, playback will continue without interruption even if the signal from the light pickup is interrupted. "Wide CAPTURE" uses a method strong in regard to vibrations in the rotation direction in addition to the conventional D.A.S.C. function, so that the sound skip guard function is made even stronger. Mechanism of D.A.S.C. Storage of digital data Digital memory Reproduced sound Note : 1. This system uses a microcomputer so it may malfunction due to external noise or interference. In such a case, unplug the power cord and remove the batteries, then re-connect the power cord and insert the batteries again. 2. Erroneous operation may occur when the headphone plug is plugged or unplugged; but this is not a malfunction. Cause Remedy Setting the D.A.S.C. The mode changes each time the D.A.S.C. key is pressed. 1 D.A.S.C. off There is no data compression, so that listening with high sound quality is possible. 2 D.A.S.C. on : 180 seconds Data are held for about 180 seconds. Turn on D.A.S.C. when moving the player or using it in areas subject to vibration. Specifications Format System ........................................................... Compact disc digital audio system Laser ..................................................................................... Semiconductor laser Audio Frequency response ........................................................ 20 Hz to 20 kHz, ± 3 dB PHONES output level (32., 1 kHz ) ............................................... 9 mW + 9 mW Line output/impedance (BASS BOOST on) .............................. 0.48 Vrms/47 k. Power supply External DC supply ................................................................................. DC 4.5 V Rechargeable batteries (NB-3A70) x 2 ................................................. DC 2.4 V Commercially-available alkaline batteries (LR03) x 2 ........................ DC 3.0 V Battery life (Fully charge) . At 0....