Stimmen - 1, Durchschnittliche Bewertung: 3
(
)
)
|
Anleitung Zusammenfassung
shuffle). Checking the settings • Press the PROGRAM button for more than 2 seconds. -*• Display indication: each stored track successively flashes for a short moment. If no program is stored, the display shows NO PROG. flOProU Erasing the program in STOP mode • Press the STOP« button to erase the program. -*■ The display shows CLEAR for a short moment, PROGRAM disappears from the display and your program is erased. HiERr Note: Interrupting the power supply or opening the lid will also erase the program. 19 Operation RESUME/HOLD RESUME - playing from where you have stopped: • Activate the RESUME feature by sliding the I RESUME/HOLD switch to the middle. -*■ The display indicates: ► pointing at the RESUME logo: UBS RESUME REPEAT • If you stop CD play by pressing the STOP ■ button, the last played position will be stored. • Press the PLAY/PAUSE Ml button to resume CD play. -*■ CD play starts from the position where it was stopped. Note: Do not open the lid. Otherwise, the information about the position last played, gets lost. HOLD - deactivating all buttons • Activate the HOLD feature by sliding the RESUME/HOLD switch to the very right. -*■ Now, all buttons are deactivated and will not function until you switch the feature off again. The lid cannot be opened. ->■ If you press a button (except OPEN), the display will indicate HOLD. Note: In the hold position, the resume function is automatically activated. 20 Maintenance Maintenance • The lens® of the CD player should never be touched! • Do not expose the CD player, batteries or CDs to rain and dampness, sand and dust or to excessive heat caused by heating equipment, or to direct sunlight, for example inside a car parked in the sun. • The lens may cloud over when the set is suddenly moved from cold to warm surroundings. Playing a CD is then not possible. Leave the CD player in a warm environment until the moisture evaporates. • Always pick up the CD by the edge and put it back in its box after use. • To clean the CD, wipe it off in a straight line from the center towards the edge using a soft, lint-free cloth. A cleaning agent may damage the disc! • You can clean the CD player with a soft and slightly dampened chamois leather. Do not use any cleaning agents as they may have a corrosive effect. • When a newly purchased CD does not stay on the hub, this is caused by small burrs around the center hole of the CD. Remove the burrs by rubbing the edge of the center hole with a pen or other such instrument. Technical specifications Frequency response................20-20,000 Hz D/A conversion.......................1 bit General Power Supply..........................AC: using the AC adaptor 230 V DC: 4 LR 6 (AA) alkaline batteries or rechargeable batteries Power consumption:...............1.0 W DC Dimensions (wxhxl)................Approx. 132 mm x 32 mm x 158 mm Weight:...................................Approx. 300 g (10 oz) Supplied accessories:.............Headphones (in-ear-type) NR 60-2-mains adapter 21 Troubleshooting Troubleshooting If a fault occurs, please check the points listed below before taking your set for repair. It you are not able to remedy a problem by following these hints, consult your dealer or service facility. Under no circumstances should you try to repair the set yourself, as this would invalidate your guarantee. Problem - Possible cause • Remedy No power or no CD play start Display: no indication Batteries -Batteries incorrectly inserted • Insert the batteries correctly - Use of new batteries • Press PLAY/PAUSE Hi -Batteries are empty • Change/recharge the batteries - Contact pins are dirty •Clean them with a cloth AC power adapter -Loose connection • Connect the adapter securely Lid of CD player does not open -HOLD feature is activated • Switch off the HOLD feature Play does not start from the first track - RESUME, SHUFFLE or PROGRAM is activated • Switch off RESUME, SHUFFLE or PROGRAM 22 Troubleshooting Troubleshooting CD play does not start or interrupts Display: no indication ERROR or NO DISC - CD lid is not securely closed • Close the lid securely - HOLD feature is activated • Switch off the HOLD feature - Moisture condensation • Leave the player in a warm place until the moisture evaporates - CD is not or incorrectly inserted • Insert a CD, label facing up - CD is badly scratched • Use another CD -CD is dirty • Clean the CD No sound or bad sound quality -PAUSE is activated •Press PLAY/PAUSE Ml - Loose or wrong connections • Check connections - Volume is not turned up •Adjust the volume - Headphones worn the wrong way round • Pay attention to the L (left) and R (right) indications - Headphone plug is dirty • Clean the headphone plug - Strong magnetic fields near the CD player • Change the players position or connections - Electrostatic discharge from the user via the CD player • Press PREV m or NEXT once or pess PLAY/PAUSE Ml twice 23 ...
Dieses Handbuch ist für folgende Modelle:Player - CDP75/B (266.91 kb)
Player - CDP75/ (266.91 kb)