Stimmen - 4, Durchschnittliche Bewertung: 3.5
(
)
)
|
Anleitung Zusammenfassung
ANTI-SHOCK ANTI-SHOCK ANTI-SHOCK ANTI-SHOCK ANTI-SHOCK ANTI-SHOCK ANTI-SHOCK ANTI-SHOCK ANTI-SHOCK 1 ANTI-SHOCK ALL ANTI-SHOCK INTRO ANTI-SHOCK INTRO ANTI-SHOCK INTRO ANTI-SHOCK INTRO ANTI-SHOCK INTRO ANTI-SHOCK INTRO ANTI-SHOCK RANDOM ANTI-SHOCK RANDOM ANTI-SHOCK RANDOM ANTI-SHOCK RANDOM ANTI-SHOCK PROG ANTI-SHOCK ANTI-SHOCK PROG ANTI-SHOCK ANTI-SHOCK PROG ANTI-SHOCK Maximum Output (Stereo Headphone..15mW+15mW(32ohm) AC Adapter......................................110V 60Hz DC....................................................4.5V with DC Adapter 3V with 2 size "AA" Batteries Do not attempt to recharge alkaline batteries . This may cause leakage and damage to the unit. Do not mix alkaline batteries with rechargeable batteries. Do not leave the batteries on recharge for long periods of time. This can damage the performance of the cells. Due to the nature of CD technology, the unit uses power even when the unit is off. To extend the batteries' life, use the adapter for indoor opera-tion or where power is supplied. Use the battery operation only when the unit is in mobile. The Dynamic Bass Boost System(DBBS) enhances the low frequency(Bass) response of the output. Set the Volume to low listening level and press DBBS switch in the direction of the arrow to turn this function ON. Note: Some CD's with DBBS may exceed the bass response capacity and can cause distortion. To avoid this, do not play DBBS in high volume. Playing DBBS in high volume may cause damage to the headphone andmore importantly, to your hearing. Hearing experts advise against the constant use of personal stereos played at high volume. Constant high volume use can lead to hearing loss. If youexperience ringing in the ears or hearing loss, discontinue use and seekmedical advice. This HOLD function prevents any unwanted function changes during PLAY or STOP mode. Slide HOLD switch to the arrow direction (or opposite) to turn the function ON (OFF). No other function buttons operate on HOLD mode, except DBBS function button. . To remove the disc from its storage case, press down on the center of the case and lift the disc out. Hold it carefully by the edges as shown below. 3. Unplug the AC adapter after charging. DO NOT CHARGE THE BATTERIES MORE THAN 24 HOURS OR MORE THAN RECOMMANED TIME. OVER CHARGINGMAY DETERIORATE THE PERFORMANCE OF THE RECHARGEABLE BATTERIES. 4.If the operating time decreases drastically after the batteries have been recharged properly, purchase new rechargeable NiCd batteries. Insert the disc into the unit with the label of the disc facing UP. Gently wipe the disc using a soft cloth from the center to the outer direction to remove dust, fingerprints or any other particles on thedisc surface. Never use chemicals, such as record sprays , anti-staticsprays, benzene or thinners to clean the CD. These chemicals candamage the disc surface permanently. To avoid serious scratches on CD, keep them in the cases after each use. Scratches can cause the laser pick-up skip in the future play. Do not place stickers or write anything on the disc. Read the instruction manual before operating this unit. Do not expose the unit to high temperature or humidity. Use dampened soft cloth to clean the unit. Do not use strong detergent or solvent to clean the unit. Ensure that all electrical connections (including the main plug, extension leads and interconnections between pieces of equipment)are properly made and in accordance with the manufacture's instructions. Consult your dealer if you are ever in doubt about the installation, operation or safety of your equipment Stop button DC jack LCD Display Play/Pause button Volume control Hold switch DBBS button Headphone jack PROG button MODE button Anti-shock button REW button General CX-CD616 1 ALL HOLD INTRO PROG RANDOM ANTI-SHOCK FF button Open door lock 2.Plug in AC adapter and slide the "CHARGE SWITCH" to "ON" position to start charging. AC Adapter Not Included SUPER SLIM PERSONAL CD PLAYER with 15 SECOND ANTI-SKIP PROTECTION Your unit operates on two (2) AA size alkaline batteries. Open the CD cover and insert the batteries in the battery compartment following the polarity diagram located inside. You can operate this unit with two "AA" rechargeable batteries. For new or exhausted rechargeable batteries, we recommend that batteries are recharged for 15 hours before use.(Refer to battery manufacturer's guide) When operating the unit with AC adapter and non-rechargeable batteries in the compartment, please make sure to set the "charge" switch to "off" position to avoid damaging the unit. 1.Open the CD cover and insert the batteries (2 X "AA" )in the battery compartment following the polarity diagram located inside BOTH BATTERIES MUST BE RECHARGEABLE NiCd TYPES OR THE BATTERIES MAY EXPLODE OR LEAK. BATTERY OPERATION (BATTERIES NOT INCLUDED) RE-CHARGEABLE BATTERY OPERATION (BATTERIES NOT INCLUDED) To replace the insert color, gently press the three points under CD door. DBBS FUNCTION HOLD FUNCTION CAUTION...