Stimmen - 3, Durchschnittliche Bewertung: 4.3
(
)
)
|
Anleitung Zusammenfassung
■ — key. 2.) Place a pre-recorded cassette tape with the open edge facing up and the full reel on the right side. 3.) Move the FUNCTION selector to the TAPE-POWER OFF position. 4.) Press the cassette PLAY -4 key to begin playback. 5.) Set the VOLUME control as desired. 6.) To advance the tape rapidly press the F.FWD <4 key. To stop the tape before it ends, press the STOP/EJ. ■ — key. 7.) To rewind the tape rapidly press the REW ►► key. To stop the tape before it ends press the STOP/EJ. ■ ± key. 8.) When the tape ends the Automatic Stop System releases the PLAY key and shuts off the tape motor. You may then open the cassette door, take out your tape, turn it around and play the other side if desired. 9.) When you finished listening, stop the tape, open the door, take out the tape and close the door. If you are playing a tape and want to switch to RADIO or CD function, make sure to press the STOP/EJ. ■ — key to disengage the tape mechanism. This move will prevent excess wear and tear to the mechanism. IMPORTANT: Always press the STOP/EJ. ■ — key to shut off the tape motor before opening the cassette door to take out your tape. The Automatic Stop System does not function in the F.FWD « and REW ►► modes. When the tape is ended in the F.FWD « and REW ►► modes, the motor continues to run. You must press the STOP/EJ. ■ — key to shut off the motor before opening the door to remove your tape. Making Tape Recording This model allows you to make tape recording directly from the CD player or radio. ■ Refer to “Playing Compact Discs” if necessary to operate the CD player. ■ Refer to “Listening To The Radio” if necessary to tune in the station you wish to record from radio. 12 1.) Press the STOP/EJ. ■ — key to open the cassette door. 2.) Insert a good quality blank cassette tape into the slot on the cassette door with the open end facing up and the full reel on the right. Use normal tape only. Do not use tape identified as “CrCfe” (Chrome) or “Metal” type tape formulations. For best result use 60 minutes (C-60) or less. Do not use 90 minutes or 120 minutes tapes as these thinner tapes are more likely to be jammed in the mechanism. 3.) Close the cassette door. 4.) When you are ready to start recording press the REC • key. The PLAY < key will also be engaged. The CD disc you are playing or the radio program you selected will be recorded directly to the tape. 5.) Press the PAUSE 11 key during recording to stop the tape temporarily or avoid recording unwanted material such as radio commercial. 6.) When you have finished recording, press the STOP/EJ. ■ — key to stop and remove the tape. Automatic Recording Volume Level Control This unit has an Automatic Level Control (ALC) circuit which controls the recording volume level and prevents overloaded and distorted recordings. The VOLUME control has no effect on recording volume level. You may change the VOLUME control setting during the recording or even reduce the volume level to “Minimum”. This will not effect the level of the recording. Stereo Headphone Jack Connect a set of stereo headphone (not included) with a 3.5mm mini plug to the Q Phones jack (located on the rear cabinet) for private listening without disturbing others. Before putting on the headphone, reduce the VOLUME control to a low level, then put the headphone on and gradually increase the VOLUME control to your desired listening level. The built in speakers are automatically disconnected when headphones is connected to the Q jack. CAUTION - Long time listening with headphone at high volume is harmful and may damage the user’s ears. 13 CARE AND MAINTENANCE About Cassette Tapes Whenever you record on a cassette any previously recorded material is erased as the new material is recorded. To prevent you from accidentally erasing material which you wish to save, blank cassettes are equipped with erase prevention tabs for each side of the tape. If the erase prevention tab for side A is removed, you cannot accidentally record on side A. The record key cannot be depressed if the erase prevention tab on the cassette has been removed. To prevent accidental erasing on side A of a cassette use a small screw driver or similar tool to break off the erase prevention tab for side A. This prevents the record key from locking. If later you do wish to record on side A of the cassette, cover the tab opening with a piece of cellophane tape. This will allow the record key to function again. TAB FOR SIDE A BREAK OUT TO PREVENT RECORDING 14 zn Cassette Care Two common causes of trouble experienced when using cassettes are: 1.) Tape jamming — Leading to uneven speed in playback, and 2.) Tape tangling—Where the tape wraps itself around vital parts of themechanism. To reduce the likelihood of these problems occurring, the following precautions should be observed: • Check that there are no loose layers of tape visible through the cassette center window (see Fig. 1). Take up any loose layers, using ...