Stimmen - 3, Durchschnittliche Bewertung: 4.3
(
)
)
|
Anleitung Zusammenfassung
Replacing The Batteries When the battery symbol flashes in the display the batteries are becoming weak and should be replaced. 4.) Close the battery door, and press the door down make sure fully locked again. 5.) Close the CD door. Always replace both batteries at the same time with new fresh alkaline batteries. Do not mix old and new batteries or different types of batteries together. If the display remains blank when you press the PLAY/PAUSE button, the batteries are completely dead. Replace them immediately. If dead batteries are left inside the battery compartment for a long period of time they may leak and cause damage to the unit, and such damage or corrosion from leaking batteries is not covered by your warranty. 5 HD7998_B081105.p65 5 11/8/2005, 15:05 6 Connecting The Stereo Headphones Connect the plug of the supplied stereo headphones to the green-colored headphone jack on the right side of the cabinet. NOTE: Make sure the headphone plug is inserted into the headphone jack as far as it will go. If the plug is not fully inserted, you may only hear sound from one side of the headphones. IMPORTANT Always set the VOLUME control to a low level before you put the headphones on and begin playing a CD. Then start playback and gradually increase the volume to a comfortable listening level. Do not play the CD at loud volume levels that might prevent you from hearing warning sounds such as car horns, etc. 20 TRACK PROGRAMMABLE CD PLAYER Green-colored Headphone Jack BATTERY PRECAUTIONS • Replacement of batteries must be done by an adult. • Do not mix old and new batteries. • Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries. • The supply terminals are not to be short-circuited. • Non-rechargeable batteries are not to be recharged. • Exhausted batteries are to be removed. • Only batteries of the equivalent type are to be used. • Batteries are to be inserted with the correct polarity. • Dispose of batteries properly. Do not dispose of batteries in fire. The batteries may explode or leak. HD7998_B081105.p65 6 11/8/2005, 15:05 LOCATION OF CONTROLS AND INDICATORS 2 3 20 TRACK PROGRAMMABLE CD PLAYER 4 5 9 10 11 12 13 14 15 6 7 8 1 7 HD7998_B081105.p65 7 11/8/2005, 15:05 1.) CD Door. 2.) Battery Compartment (Inside CD compartment). 3.) DC 4.5V Input Jack – Connect an AC adapter (not included) to this jack to use 120V 60Hz AC house current. 4.) HOLD (On/Off) Switch – Slide to the right to lock the function of the control buttons. 5.) EQ Button – Press repeatedly to select ROCK, SRR, POP, Flat EQs. 6.) Open “ ” Switch – Slide to the right to unlock and open the CD door. 7.) VOLUME + / – Buttons – Raises or lowers the volume. 8.) Headphone Jack – Connect stereo headphones, included, to this jack. 9.) MODE Button – To select the playback mode: Repeat 1/ALL, INTRO or SHUF (Shuffle). 10.) PROG (Program) Button – To program the playback tracks. 11.) SKIP/SEARCH Forward Button. 12.) SKIP/SEARCH Reverse Button. 13.) STOP Button. 14.) PLAY/PAUSE Button. 15.) LCD Display – Shows Track number, Elapsed Time, Program, Repeat, Shuffle, and Intro modes. 8 HD7998_B081105.p65 8 11/8/2005, 15:05 LCD DISPLAY INDICATORS LCD DISPLAY INDICATORS 3 456 1 2 7 8 910 1.) PGM (Program) Indicator – Appears when programming tracks or playing programmed tracks. 2.) ROCK, SRR, POP Indicators – Appears when repeatedly pressing the EQ button to select the corresponding EQ setting. 3.) VOL Indicator – Appears when pressing the VOLUME + or – buttons to adjust the volume level. 4.) 1/ALL Indicators – Appears when the Repeat playback mode is selected. 5.) INTRO Indicator – Appears when Intro playback mode is selected. 6.) SHUF (Shuffle) Indicator – Appears when Random playback mode is selected. 7.) HOLD Indicator – Appears when HOLD switch is set to ‘On’position. 8.) Battery Status Indicator – Flashes when battery level becomes low. 9.) Elapsed Time Display. 10.) Track Number Display. 9 HD7998_B081105.p65 9 11/8/2005, 15:05 OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS General Controls HOLD Switch The HOLD switch on the right side of the cabinet must be in the ‘Off’ (left) position to start the CD player. If you plan to carry the CD player in a handbag, briefcase, school bag, back pack, etc, slide the HOLD switch to the ‘On’ (right) position. While the HOLD switch is ‘On’, all the control buttons are disabled. This prevents the player from starting accidentally by something pressing against the PLAY/PAUSE button. HOLD (Off After you begin CD playback you may also slide the HOLD switch to the ‘On’ (right) position to disable all the controls on the CD door. You can then place the player in a handbag, backpack, etc, and do not have to worry that the player will be accidentally turned off by something pressing against the STOP button or Track Skip buttons. EQ (Preset Equalizer) Button During CD playback you may press the EQ button to select the preset equalizer setting ROCK, SRR, POP, Flat (EQ ‘Off’) as desired. VOLUME + ...