Stimmen - 2, Durchschnittliche Bewertung: 4.5 ( )

Hersteller: Black & Decker Dateigröße: 2.46 mb Dateiname: Unterrichtssprache:

However, after several charge and discharge cycles, the battery will be back up to its full capacity. 3. While charging, the Charger may hum and become warm to touch. This is a normal condition* and does not indicate a problem. 4. If the battery does not charge properly—(!) check power supply at receptacle by plugging in a lamp or other appliance, (2) check to see if receptacle is connected to a light switch which turns power of when you turn out the lights, 5. Whenever you unplug the Charger from its power supply, also disconnect the Pencil from the Charger. 6. Never expose Charger to weather; use indoors only. 1, Attach charger cord to Pencil as shown in Figure 2. Arrange cord so that it will not be exposed to any danger of being cut or damaged. 2, Plug Charger into any 120-Volt receptacle, Figure 3. Your tool is now on charge, CAUTION —This Charger can be used only with 120 volt, normal house current. . ~ . 3, Recharging the tool requires, on the average, about 16 hours to reach full capacity. Don’t worry about over-charging the tool as it can be left on charge indefinitely without harm. In fact, you can leave the tool on charge continuously so that it will always have a full charge and be ready when, you need it, Or, remember to put your tool on charge the day before you need it and it will be ready to go at full charge, ' ■ ATTACHING & REMOVING TIPS To attach tip, insert tip carefully into pencil with a slight turning motion (Figure 4A), Push firmly until tip stops. Be sure that larger diameter shaft is visible in the front set screw hole (figure 4B), Turn tip until flat soldering surface is in the position convenient for your soldering job. Place first set screw from envelope on the alien wrench and tighten in rear hole (Figure 4C), Tighten set screw only enough to hold tip in pencil. Do not overtighten, Pull on tip gently to mate certain that the screw is seated, Place the second set screw into the front hole and tighten, . , To remove tip, allow it to cool. Then loosen both set screws and pull tip out. Remove forward set screw completely before installing another tip. SWITCH Pressing the switch button turns the tool “ON” {Figure 5), The tip will quickly reach soldering temperature. Releasing the button turns the tool “OFF.” CHARGING THE BATTERY TINNING FIG. 3 The soldering tip that comes with your Pencil has already been “tinned,” that is, covered with a thin coating of solder. The tip should always be coated in this manner when not in use, Just before soldering, the old tinning on the tip should be removed and fresh tinning applied. To do this, press the switch button until the coating of solder on the tip melts (about 6 seconds). Release switch and quickly wipe off both sides of tip on a damp sponge. Reheat tip and apply a fresh coating of solder to both sides of tip. You are now ready to solder. Always use rosin core solder or rosin flux for electrical connections, never use add core solder or acid flux....

Herunterladen

Geben Sie zwei Ziffern: