Stimmen - 3, Durchschnittliche Bewertung: 3.7
(
)
)
|
Anleitung Zusammenfassung
A single model supports both 120 and 220-240 Volt electronic and magnetic low-voltage, incandescent, neon/cold cathode, two wire dimmable fluorescent and non-dimmable lighting loads up to 5 Amps per channel, 10 Amps total. Features and Functions • Four channels of forward or reverse phase dimming • Auto load detection • 120-240 Volt 50/60 Hz operation • Selectable non-dim mode • “Wilson” filter eliminates lamp flicker • Short circuit and overload protection • Master air gap relay • Override input • Cresnet® communications • Setup via front panel or software • Programmable functionality via DIN-AP2 or other 2-Series control system • 12M wide DIN rail mounting Auto Load Detection Each channel of the DIN-1DIMU4 is capable of auto-detecting the dimmable load type connected to it and selecting the appropriate operating mode to control that load. Reverse phase (trailing edge) mode supports incandescent and electronic low-voltage load types, while forward phase (leading edge) mode handles magnetic low-voltage, neon and other inductive load types. A non-dim mode is also selectable for switching of non-dimmable lighting fixtures. Any channel may be set for any mode, allowing one dimmer module to handle any combination of lighting types on four separately controlled circuits. Wilson Filter A Crestron® proprietary zero cross filter technology, known as a Wilson filter, provides superior immunity to noise on the power line, eliminating lamp flicker and compensating for variations in the line voltage and frequency. Short Circuit Protection Built-in OCP (over current protec...