Stimmen - 3, Durchschnittliche Bewertung: 3.7
(
)
)
|
Anleitung Zusammenfassung
6. BUCKET FULL Indicator ---This light glows when the bucket is full and needs to be emptied. It also glows, when the bucket is not properly positioned. When bucket full indicator light glows, the compressor and fan will turn "OFF". 7. AUTO RESTART ---Once the power is restored after a power outage, the unit begins to operate at its previous operation setting. The fan will run by default for 2 minutes. After 2 minutes both fan and compressor will be ON or OFF depending on the humidity conditions. TO OPERATE THE DEHUMIDIFIER: 1. Plug the power cord into the electrical outlet. Press the POWER key. 2. Set the Humidity control anywhere between 35% to 70% for normal operation. • For less humidity, press the HUMIDITY CONTROL key. • For higher humidity, press the HUMIDITY CONTROL key. 3. Press the TIMER key, to set the amount of time for which you want the unit to cycle On and Off. The time can be set for 2 hours or 4 hours. 4. If you want to change the fan speed, press the FAN SPEED key. Each time the FAN SPEED key is pressed the fan speed changes as High Low High. 5. Press the POWER key to stop the unit manually. NOTICE Water bucket must be properly installed. • The dehumidifier will not run if the bucket is not properly installed. • The dehumidifier shuts off when the desired humidity setting is reached. ENGLISH Owner’s Manual 11 12 Dehumidifier Operating Instructions Water level control switch ENERGYSTAR The dehumidifier will turn off automatically when the bucket is full, or when the bucket is removed or not replaced in the proper position. The bucket must be replaced in the proper position for the dehumidifier to work. The light will be on and the dehumidifier will not run if the bucket is not in the proper position. 1. Empty the bucket manually. 2. Attach a length of garden hose to the threaded drain hose connection to carry water to the drain. When the bucket is full, pull out by grasping the handle and empty it into a large sink or tub and then replace it properly. Do not remove while operating the dehumidifier. It can cause water to drop on the base pan or the floor. Empty the bucket when the indicator light turns on. It is advisable to carry the bucket by supporting it from the bottom as well as by the handle. Carrying by only the handle may cause the handle or bucket cover to break. 1. Remove the drain-hole cover. 2. Connect a garden hose to the threaded drain hose connector. 3. Push hose connector tightly to the drain-hole on Rear Grille. The hose attachment will accept a standard garden hose fitting. Do not over tighten the hose when connecting it to the hose connector, use a rubber washer and tighten by hand firmly without stripping the plastic threads. When being attached to hose connector drain hose connection, do not bend or kink the hose. The hose should lie flat from the dehumidifier to the drain. NOTICE NOTICE NOTICE Automatic shut off Disposing of collected water HOSE-CONNECTOR DRAIN HOLE COVER INSERT TAKE OUT ConstantlyOn. FAN SPEED TIMER High Low 4hr.On/Off 2hr.On/Off HUMIDITY CONTROL BUCKET FULL POWER AUTORESTART HUMIDITY SETTING ENERGYSTAR ENGLISH Owner’s Manual 13 Installation 12" 12" ConstantlyOn. FAN SPEED TIMER High Low 4hr.On/Off 2hr.On/Off HUMIDITY CONTROL BUCKET FULL POWER AUTORESTART HUMIDITY SETTING ENERGYSTAR ConstantlyOn. FAN SPEED TIMER High Low 4hr.On/Off 2hr.On/Off HUMIDITY CONTROL BUCKET FULL POWER AUTORESTART HUMIDITY SETTING ENERGYSTAR ConstantlyOn. FAN SPEED TIMER High Low 4hr.On/Off 2hr.On/Off HUMIDITY CONTROL BUCKET FULL POWER AUTORESTART HUMIDITY SETTING ENERGYSTAR ConstantlyOn. FAN SPEED TIMER High Low 4hr.On/Off 2hr.On/Off HUMIDITY CONTROL BUCKET FULL POWER AUTORESTART HUMIDITY SETTING ENERGYSTAR ConstantlyOn. FAN SPEED TIMER High Low 4hr.On/Off 2hr. On/Off HUMIDITY CONTROL BUCKET FULL POWER AUTORESTART HUMIDITY SETTING ENERGY STAR 1. Allow at least 12 inches of space on all sides of the unit for good air circulation. 2. Install your dehumidifier on a floor, table, or shelf. When installing the dehumidifier on a table or shelf, make sure the table or shelf is strong enough to support the weight of the dehumidifier with a full bucket. Do not sit or stand on the dehumidifier. Secure wheels with blocks to prevent unit from falling when installed on a table or shelf. The height of a table or shelf might provide a better position from which to handle the bucket and help prevent icing of the coils due to colder air near the floor (such as in a basement.) 3. Lift the bucket and place it in the dehumidifier, making sure the slots on the bottom side of the bucket are positioned correctly. 4. Rollers let you move the dehumidifier easily. NOTICE 1. Pull out the bucket cover. 2. Brush off the residue in the bucket. Clean the bucket by wiping with a brush or a cloth dampened in a mild detergent solution. 3. Close the cover. Push the tabs on the top of the bucket when installing the bucket. NOTICE NOTICE • Use the dehumidifier in a basement to help prevent moisture damage. • Us...