Stimmen - 4, Durchschnittliche Bewertung: 4 ( )

Hersteller: Kenmore Dateigröße: 4 mb Dateiname: Unterrichtssprache:

TO CHANGE is equipped FAN SPEED: with Electronic Control Protection There is a 2 Pninute delayed start when YOU WILL SEE: some settings ar Press Fan Pad TO RAISE HUMIDITY SET POINT: YOU WILL SEE: Press "A" Arrow Up 1 Whichever you choose i TO LOWER HUMIDITY SET POINT: YOU WILL SEE: Press "V" Arrow Down , Whichever you choose Note: When the down arrow "v" is pressed the unit will stop running if the level of dehumidification has been reached When the room humidity increases the unit will start running again,, 4 Electronically Controlled Dehumidifier Operating Instructions (continued) OTHER FEATURES: When the water receptacle is full the "FULL" light will be lit and the unit wilt Shut-Off. This is the time to empty the bucket (The Dehumidifier wilt not operate while the bucket is removed) Following emptying the accumulated water, replace the bucket and the Dehumidifier wil! operate at the last setting chosen_ FULL BUCKET Light TO TURN DEHUMIDIFIER OFF Press ON/OFF Pad Moisture Removal Dehumidifier Features At first, the dehumidifier wilt remove large amounts of moisture tt will continue to do so until the relative humidity is reduced to a point where moisture damage wilt not occur Then, the amount of moisture removed from the air will be a tot less, This indicates the dehumidifier is operating effectively and is maintaining the relative humidity at the desired level..Judge the performance of the dehumidifier by the elimination of dampness and dampness odors, not by the amount of water being deposited in the bucket When bucket has filled with water, unit will turn off. All models feature an Automatic Shut-Off light that will glow unti! bucket is emptied and returned to the proper position Operating Conditions A dehumidifier wilt not operate satisfactorily if room temperature is 65°F (18°C) or lower, or if the humidity in the room is low Under these conditions, the dehumidifier should be turned off A dehumidifier wifl not eliminate frost on windows during winter, The dehumidifying coil normally operates above freezing temperatures and cannot prevent moisture from condensing on the inside of a window pane that is below freezing. TIP: tt may be helpful to use a dehumidifier in the kitchen or laundry area where the humidity is high, Reducing humidity in these areas may reduce frost on windows in other parts of the home Dehumidifier Features (continued) Removing Collected Water Figure 1 Figure 2 Frost Control The Frost Contro! feature prevents frost or ice from remaining on the dehumidifying coil for an extended period of time, When frost formation occurs, this control turns off the compressor, The fan continues to run, causing any frost or ice to melt,, Dehumidifier will then resume normal operation Frost Control is also designed to prevent excessive on-off cycling Under certain conditions this may allow frost to remain on coil for some time before the compressor turns off and the frost is cleared Bucket and Float Installation All models are supplied with a bucket, which is conveniently tucked into the front of the unit to accumulate water removed from the air, or use the built-in hose connection to carry water directly to a drain. VVhen using the bucket the Automatic Shut-Off switch is activated by a float The Automatic Shut-Off switch stops the unit before the bucket overflows, and turns the unit on again after the bucket is emptied and replaced The bucket and float must be installed correctly for proper operation (Figure I) Bucket Cleaning Instruction Periodic cleaning with a mild detergent and water will prevent the growth of mold, mi!dew and bacteria, Remove bucket as shown in Figure 2 Direct Draining If you want the water to flow directly to a drain, you must first remove the hose cap (Figure 2) To remove hose cap, use a standard screwdriver and turn counterclockwise Connect any standard garden hose to the bucket connection, or place the dehumidifier over the drain A standard garden hose has a 3/4" (t9 ram) diameter connection with 11'.2 threads per inch Note: When using either of the above direct draining methods, you must first drill a 3/8" (I 0 mm) hole in the center of the bucket connection. (For ease of drilling use locating mark to center drill bit for hole (Figure 3)) This will allow water to flow freely through the connection To resea! the hose connection to the bucket, use any standard hose end cap The hose cap cannot be used to reseal the hole. Locating Hole IMPORTANT: Do not drink the water collected in the bucket. Figure 4 Figure 3 6 Avoid Service Checklist Before calling for service, review this problem occurrence list. It may save you time and expense, because some of the occurrences are not the result of defects in materials or workmanship, and would not be covered by the warranty, OCCURRENCE SOLUTION DEHUMIDIFIER DOES NOT OPERATE° Electronic Contro! Protection, Bucket was removed ...

Herunterladen

Geben Sie zwei Ziffern: