Stimmen - 3, Durchschnittliche Bewertung: 4 ( )

Hersteller: GE Dateigröße: 539.43 kb Dateiname: ce150785-946a-40da-b2db-48fcb3a5e92e.pdf Unterrichtssprache:

Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded. Where a 2-prong wall outlet is encountered, it is your personal responsibility and obligation to have it replaced with a properly grounded 3-prong wall outlet. The dehumidifier should always be plugged into its own individual electrical outlet, which has a voltage rating matching the rating plate. This provides the best performance and also prevents overloading house wiring circuits, which could cause a fire hazard from overheated wires. 2 ge.com Consumer SupportTroubleshooting Instructions Care and USE OF EXTENSION CORDS Because of potential safety hazards under certain conditions, we strongly recommend against the use of an extension cord. However, if you must use an extension cord, it is absolutely necessary that it be a UL-listed, 14 gauge, 3-wire grounding type appliance extension cord having a grounding type plug and outlet and that the electrical rating of the cord be 15 amperes (minimum) and 125 volts. Because of potential safety hazards under certain conditions, we strongly recommend When disconnecting the power cord from the adapter, always hold the adapter in place USE OF ADAPTER PLUGS against the use of an adapter plug. However, if you must use an adapter, where local codes permit, a temporary connection may be made to a properly grounded 2-prong wall outlet by use of a UL-listed adapter available at most local hardware stores. The larger slot in the adapter must be aligned with the larger slot in the wall outlet to provide proper polarity in the connection of the power cord. with one hand while pulling the power cord plug with the other hand. If this is not done, the adapter ground terminal is very likely to break with repeated use. If the adapter ground terminal breaks, DO NOT USE the dehumidifier until a proper ground has been established. Attaching the adapter ground terminal to a wall outlet cover screw does not ground the appliance unless the cover screw is metal, not insulated, and the wall outlet is grounded through the house wiring. You should have the circuit checked by a qualified electrician to make sure the outlet is properly grounded. READ AND FOLLOW THIS SAFETY INFORMATION CAREFULLY. SAVE THESE INSTRUCTIONS 3 About the controls on the dehumidifier. Consumer Support Troubleshooting TipsOperating InstructionsSafety InstructionsTroubleshooting Tips Care and Cleaning Safety InstructionsOperating Instructions % Controls POWER Pad Press to turn the dehumidifier on and off. HUMIDITY CONTROL Pads The humidity level can be set within a range of 35% RH (Relative Humidity) to 70% RH (Relative Humidity) in 5% increments. For drier air, press the pad and set to a lower percent value (%). For damper air, press the pad and set to a higher percent value (%). When you first use the dehumidifier, set the humidity control to 45% or 50%. Allow at least 24 hours for the dehumidifier to achieve the humidity level. If you still have damper air than desired, set the humidity level to a lower setting. Other Features FAN SPEED Pad Controls the fan speed. Press to set to HIGH or LOW fan speed. Set the fan control to HIGH for maximum moisture removal. When the humidity has been reduced and quiet operation is preferred, set the fan control to LOW. HUMIDITY LEVEL DISPLAY Displays percent humidity level. Its accuracy is (+/– 5%). BUCKET FULL LED Indicates presence of bucket and its fill level. BUCKET FULL Light Glows when the bucket is ready to be emptied, or when the bucket is removed or not replaced in the proper position. Auto Shut Off The Water Level Control Switch shuts off the dehumidifier when the bucket is full, or when the bucket is removed or not replaced in the proper position. Also, when the bucket is out of position, the unit will beep 3 times. Auto Defrost When frost builds up on the cooling coils, the compressor will cycle off until the frost disappears. The fan continues to run. Power Outage If a power outage occurred or if the unit was unplugged, the unit will display its prior setting. Note: If ON is in the display, the dehumidifier is operating continuously, but a specific humidity level is not set. You will need to reset the HUMIDITY CONTROL to the desired level. Auto Restart Once power is restored after a power outage, the unit automatically resumes operation after a 2 minute delay. 4 7 Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support Care and cleaning of the dehumidifier. ge.com Turn the dehumidifier off and remove the plug from the wall outlet before cleaning. Grille and Case To clean the case: Use water and a mild detergent. Do not use bleach or abrasives. If cabinet paint chips, you can touch it up with a good grade enamel paint to prevent rust. To clean the front grille: Use a vacuum attachment or brush. Air Filter The air filter is on the back of the dehumidifier. It should be checked and cleaned at least every 30 days or...

Herunterladen

Geben Sie zwei Ziffern: