Stimmen - 2, Durchschnittliche Bewertung: 4.5
(
)
)
|
Anleitung Zusammenfassung
supply cord -4 To reducetheriskoffire,electricshock,or injuryt:opersons,readtheimpo_antSAFETY instructionssectionbeforeoperatingthisappliance. 1.Controlpanel 2. Frontgrille 3. Powercord 4, Cabinet 5, Airfilter 6.Waterbucket 2 IMPORTANT: Whenunitis firstpluggedin or aftera poweroutage,therewillbe a 2 minutedelaybeforeoperation begins. 5 6 -5 CONTROL PANEL Your dehumidifier control panel contains a Bucket: Full indicator, a Humidity indicator, a Power Control, Humidi_ Control, Fan Speed Control and Timer Control. Bucket Full indictor ---This light:glows when the water bucket: is full and needs to be emptied. Power --Operation star_ when this button is pressed and stops when the but_n is pressed again, Humidi_ Control ---This button controls the humidity in the r_m, • : To raise the humidi_ setting • : To lower the humidity' setting , The humidity can be set within a range of 40% RH(Relative Humidity)~70% RH(Relative Humidity) by 5% increments, Fan Speed .... This controls the speed of the airflow. -High: Fan speed is set to high. • Low: Fan speed is set to low. • When Fan Speed button is pressed, the fan speed mode is changed, Energy Timer .... Pressing this button will make the unit go into automatic On/Off mode In this mode the unit will be On for 3 or 6hrs and then it will automatically _rn off for 3 or 6hrs. After that it will turn on again and this cycle will be repeated continuously. (Constant button will make the unit run continuously under normal humidity conditions.) • The Timer can be set for: Constant, 6 Hr. On/Off or 3 Hr. On!Off • When Timer button is pressed, the Timer indicator lights shift as follows: Constant _ 3 Hr. On/Off _ 6 Hr. On!Off _ Constant Auto Restart ---In case the power comes on again after a power failure, Auto Restart Operation is the function to operate proc_ures automatically to the previous operating conditions. So there is no need of activating this function by pressing any key or button. TO OPERATE THE DEHUMIDIFIER: 1..Plug the power cord into an electrical outleL Press the power button. 2. Set the,Humidity Control anywhere bei_ween40% RH(Relative Humidity) and 70% RH(Relative Humidity) for normal operation_ if you need drier air, press the Humidity Control button. If you need less moister air, press the Humidi_ Control button 3. Press the Power button to stop the unit manually. 4. Press the Timer button to set the amount of time you want the unit to run, At the end of that time, the unit will shut off. The Timer can be set for : Constant, 6 hours or3 hours. 5. If you want to control the speed of airflow, press Fan Speed button. Each time that the Fan Speed button is press_, the fan speed mode is shifted: High _ Low -,-)High Note: Be careful not to lose the water bucket. This dehumidifier doesn't run if the water bucket is not installed properly. -6 • Installthedehumidifieronalevelfloorstrong enoughto supporttheunitwith afull bucket !2~18" of water. • Forbestperformance,allowatleast12-18 inchesofair spaceon all sidesof theunitfor goodair circulation. • Keepalloutsidedoors,windows,andother openingsclosedwhenoperatingthe dehumidifier.Humidoutdoorairwil!addto the unit'sworkload. • Install your dehumidifier in an area where the temperature will not fall below 65_ (18_). At temperatures below this, the coils can become covered with frost, which may reduce dehumidifying performance. DEFROST CONTROL When the defrost control senses frost build-up on the evaporator coil, it will automatically shut off the compressor. The fan will continue to run to draw air across the coil and melt the frost. When the coil is defrosted, the compressor will automatically restart and dehumidifying resume, • Use the dehumidifier in a basement to help prevent moisture damage. • Use the dehumidifier in cooking, laundry, bathing, and dishwashing areas that have excessive moisture. , Use the dehumidifier to prevent moisture damage anywhere books or valuables are stored. -7 Whenthebucketisfull,orwhenthebucketisnotintheproperposition, the Bucket Ful! bightturns on and the unit automatically shuts off. Also, when bucket is out of position, the unit will beep 3 times. me bucket must _ replaced in the proper position for the dehumidifier to work. The light will be on and the dehumidifier will not run if the bucket is not in the pro_r position. The water bucket can be emptied Empty the bucket manually. When the bucket is full, remove and empty it into a large sink or tub. When finished, replace it properly. NOTE: To replace the bucket properly, make sure the slots on the back of bucket are positioned correctly. in one of three ways: Pla_ the dehumidifier dir_tly over drain. The bucket has a threaded hose connection which can be left open. Drill a 1/4" (6.4ram) to 1/2"(13mm) hole in the center of the hose connection. Once opened, the hose connection will continually drain water from the bucket Attach a garden ho_ to the thread_ bucket drain hose conn_tion to carry water to the drain. (HAND TIGHTENONLY) Be sure t...