Remove the cord and plug it into an electrical outlet. There are two quick release cord wraps for easy cord removal, and a cord clip that is part of the upper cord wrap where you can attach the cord when vacuuming. 2. When finished cleaning, turn vacuum cleaner off. Unplug power cord by grasping the polarized plug (NOT the cord) and disconnect from outlet. 3. Return Quick Release cord wrap to original position and loop power cord around cord wrap. Clip molded plug to power cord to secure. 6 Quic
Always place vacuum cleaner on the floor with handle in upright position when using tools. Never place your fingers under the cleaner when it is running. Never place powerfoot on furniture or uneven surfaces. Do not place vacuum cleaner close enough to objects to pull them into rotating brush. 9 800.237.7691 Maintenance and care to maximize your cleaning performance and extend the life of your vacuum, it is very important that you empty your dirt container and check and clean your filters freque
With rotating floor brush removed from vacuum cleaner (Steps 1-4 of "Check rotating floor brush and drive belt"), grasp old drive belt and remove from motor pulley. Discard old drive belt. 3. Place new drive belt over motor pulley and stretch other end over rotating floor brush in the space between the bristles. 4. Place ends of rotating floor brush down into slots on sides as shown. 5. Turn rotating floor brush by hand several times in direction of motor pulley. If properly installed, drive bel
¦ Do not incinerate the appliance even if it severely damaged. The batteries can explode in a fire. ¦ Do not put any object into opening. ¦ Do not use with any opening blocked. ¦ Keep openings free of dust, lint, hair and anything that may reduce airflow. ¦ Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts. ¦ Use extra care when cleaning stairs. ¦ Do not pick up flammable or combustible liquids. (lighter fluid, gasoline, kerosene, etc.) or use in areas
To turn hand vacuum ON ( I ), press up. To turn hand vacuum OFF ( 0 ), press down. 2. Cleaning with hard nozzle 1. Turn hand vacuum OFF. 2. Remove flexible rubber contour nozzle by pressing down on round nozzle release button. 3. Replace with hard nozzle by lining up the bottom of nozzle to the bottom of the dirt 3. container. Pivot upwards to snap into place. 4. Make sure the nozzle has snapped securely into place before using. 4 Power Cord with Cord Wrap System Exhaust ug110-4076_87R4E_1008.in
Storing in the upright position b2. telescopingextensionwand)intothe storageslotonthebottomofthevacuum. 165 Power button turn the power on or off by pressing lightly downward on the power button ( ). Power cord the power cord is located at the rear of the vacuum. Gently pull out the power cord, watching for the yellow line. Stop pulling the power cord once the yellow line is visible. there is also a red line, which indicates the end of the usable cord. Do not pull the power cord out beyond the r