Stimmen - 0, Durchschnittliche Bewertung: 0
(
)
)
|
Dieses Gerät hat auch andere Anweisungen:
Anleitung Zusammenfassung
Follow the procedures in Before Working Inside Your Computer. 2. Remove the battery from the computer. 3. Remove the access panel from the computer. 4. Remove the fan from the computer. 5. Remove the heat sink from the computer. 6. Using a plastic scribe, rotate the processor cam lock counterclockwise. 7. Lifting straight up, remove the processor from the computer. WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at Replacing the Processor To replace the processor, perform the above steps in reverse order. Back to Contents Page Back to Contents Page Speakers Dell™ Latitude™ E5510 Discrete Service Manual Removing the Speakers 1. Follow the procedures in Before Working Inside Your Computer. 2. Remove the battery from the computer. 3. Remove the access panel from the computer. 4. Remove the optical drive from the computer. 5. Remove the LED cover from the computer. 6. Remove the keyboard from the computer. 7. Remove the display assembly from the computer. 8. Remove the LED board from the computer. 9. Remove the palm rest from the computer. 10. Remove the fingerprint reader from the computer. 11. Remove the screws securing the touchpad cover bracket to the palm rest. 12. Lift up the touchpad cover bracket and remove it. WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at 13. Peel open the tapes securing the speaker cables to the palm rest. 14. Peel open the tape securing the touchpad data cable to the palm rest, and pull out the cable from the hole. 15. Release the speaker cables from the routing path. 16. Remove the screws securing the left and right speakers to the palm rest. 17. Lift up the left and right speakers and remove them. Replacing the Speakers To replace the speakers, perform the above steps in reverse order. Back to Contents Page Back to Contents Page Technical Specifications System Information Memory Audio ExpressCard Fingerprint Reader (Optional) Display Touchpad AC Adapter Environmental Processor Video Communications PC Card Ports and Connectors Keyboard Battery Physical NOTE: Offerings may vary by region. For more information regarding the configuration of your computer, click Start® Help and Support and select the option to view information about your computer. System Information Chipset Intel® HM55 Express Chipset Data bus width 64 bits DRAM bus width dual-channel 64 bits NOTE: You must install memory in pairs for dual-channel mode to work. Processor Types Intel Core™ i3 series Intel Core i5 series Intel Core i7 series Intel Celeron™ L2 cache 2 MB, 3 MB, and 4 MB Memory Type DDR3 1333 MHz SDRAM (operating at 1066 MHz) Connectors two SODIMM slots Module capacities 1 GB, 2 GB, and 4 GB Minimum memory 1 GB Maximum memory 8 GB NOTE: Only 64-bit operating systems can detect memory capacities greater than 4 GB. Video Type Intel UMA video Data bus integrated video Controller Intel Graphics Media Accelerator HD Output 15-pin video connector Audio Type four channel high definition audio (HDA)codec Controller IDT 92HD81B Stereo conversion 24-bit (analog-to-digital and digital-to-analog) Interfaces Internal high definition audio bus External microphone-in/line-in connector and stereo Speakers two Volume controls volume up, volume down, and mute buttons Communications Modem internal (optional) Network adapter 10/100/1000 Mbps Broadcom NetXtreme 5761E Gigabit Ethernet Controller Wireless internal wireless local area network (WLAN), wireless wide area network (WWAN), and Bluetooth® wireless support GPS autonomous, A-GPS ExpressCard ExpressCard connector 28-pin connector Cards supported 54 mm, 34 mm with adapter PC Card PC Card connector 80-pin connector Cards supported type I card or type II card Fingerprint Reader (Optional) Type AuthenTec swipe fingerprint sensor Ports and Connectors Audio microphone connector stereo headphone/external speaker connector Video 15-pin VGA video connector Network adapter RJ-45 connector USB four USB 2.0-compliant connectors Memory card reader 3-in-1 memory card reader IEEE 1394a 4-pin connector Serial port one E-family docking connector 144-pin docking connector Display Type HD anti-glare LED HD+ wide view anti-glare LED Active area (X/Y) 344.20 mm x 193.50 mm (13.55 inches x 7.61 inches) Dimensions Height 210.00 mm (8.26 inches) Width 360.00 mm (14.20 inches) Diagonal 396.24 mm (15.60 inches) Maximum resolutions HD 1366 pixels x 768 pixels HD+ 1600 pixels x 900 pixels Typical brightness HD 220 nits HD+ 250 nits Operating angle 0 degree to 180 degrees Refresh rate 60 Hz Minimum Viewing angles Horizontal HD 40 degrees/-40 degrees HD+ 55 degrees/-55 degrees Vertical HD 15 degrees/-30 degrees HD+ 45 degrees/-45 degre...