Stimmen - 3, Durchschnittliche Bewertung: 5 ( )

Hersteller: Toshiba Dateigröße: 3.67 mb Dateiname: Unterrichtssprache:

Avoid touching the connector on the memory module or on the computer. Grease or dust on the connector may cause memory access problems. 9 If replacing an existing memory module, remove this memory module by performing steps 2-3 of “Removing a memory module” on page 48. 10 Carefully remove the new memory module from its antistatic packaging, without touching its connector. 11 Locate the empty memory module slot on the underside of the computer. Getting Started Getting Started Adding memory (optional) 12 Pick up the memory module by its sides, avoiding any contact with its connector. Position the module toward the socket, aligning the connector’s notch with the matching key in the socket. latch latch key notch connector (Sample Illustration) Aligning the memory module with the socket 13 Firmly press the memory module into the memory slot’s socket at approximately a 30-degree angle (to the horizontal surface of the computer). (Sample Illustration) Inserting the memory module into the socket 46 46 46d Adding memory (optional) 14 Once the module’s connector is fully inserted into the socket, press downward on the top edge of the module to seat the module into the latches at the sides of the socket. These latches should “snap” into place securely with the corresponding cutouts in the side of the module. If the latches and cutouts do not line up correctly, repeat steps 13-14. latch latch (Sample Illustration) Pressing down on the memory module Do not force the memory module into position. The memory module should be completely inserted into the socket and level when secured in place. (Sample Illustration) Inserting the memory module into the slot Memory slot Front of computer 15 Replace the memory module slot cover and secure it using the screw. Getting Started Getting Started Adding memory (optional) 16 Re-insert the main battery. For more information on inserting the main battery, see “Inserting a charged battery” on page 109. 17 Turn the computer right side up. Make sure to remove the soft cloth from the work surface before restarting the computer. Always make sure your computer and AC adaptor have adequate ventilation and are protected from overheating when the power is turned on or when an AC adaptor is connected to a power outlet (even if your computer is in Sleep mode). In this condition, observe the following: . Never cover your computer or AC adaptor with any object. . Never place your computer or AC adaptor near a heat source, such as an electric blanket or heater. . Never cover or block the air vents including those located at the base of the computer. . Always operate your computer on a hard flat surface. Using your computer on a carpet or other soft material can block the vents located at the base of the computer. Overheating your computer or AC adaptor could cause system failure, computer or AC adaptor damage or a fire, possibly resulting in...

Herunterladen

Geben Sie zwei Ziffern: