Note: The manufacturer is not responsible for any radio or TV interference cause by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment. These devices and their antenna(s) must not be co-located or operated in conjunction with any other antenna or transmitter. 3 22 4 6 7 2 24 10 19 9 20 21 23 1 13 16 14 17 15 12 18 28 27 + - 25 11 + - 26 26 Thank you for purchasing Azden’s 105 wireless microphone system. Depending on which sys

Channel Selectivity . 67 dBm Intermodulation . 62 dBm Noise Reduction Expander (TOKO) Audio Output -22 dBm (balanced) @ 1 kHz ± 40 kHz Output Impedance 2 k . (balanced) S/N Ratio 57 dB (± 5 kHz) Power Reqirement 2 “AA” Batteries (Alkaline) - 6-8 hours runtime Dimensions 63W x 98H x 27D mm 2.48W x 3.86H x 1.06D inches Weight .180 g (6.35 oz) w/batteries 15BT Belt-pack Transmitter RF Power 25 mW Antenna 1/4 wavelength Frequency Response 50 Hz - 15 kHz Reference Deviation ± 5 kHz (-60 dBm - 1 kHz i

(7) LED indicator This LED turns RED when the receive is turned “ON” and GREEN when receiving a signal from the transmitter. HANDHELD MICROPHONE/TRANSMITTER (15HT) (25) Remove the battery compartment cover by rotating it counterclockwise and sliding it down. (26) Insert two fresh Alkaline “AA” batteries into the compartment. Make sure the battery polarity is correct as marked inside the battery compartment. Inside the battery compartment you will also find #27 and #28 (27) MIC LEVEL Control The

With the frequency CHANNEL dial on the right (column B on the included chart) you can select any of 10 frequency channels (numbered 0-9). There are actually 92 possible selections. (14) POWER This switches the transmitter “ON or “OFF” (15) MIC Input Jack Plug the supplied EX-503L microphone into the MIC jack and tightened the collar until it is snug (DO NOT OVERTIGHTEN). In addition to the EX-503L, other lapel and/or headset microphones with 3.5mm plugs can also be used with the 15BT. (17) Audio

Lecturers, Actors, Actresses, etc. Model 31IT: Instrument body-pack transmitter. Designed for electric guitar and bass. 32BT Lavalier Microphone with body-pack transmitter: (1) Open the battery compartment lid by sliding it in the direction indicated and raising it. (2) Insert one fresh Alkaline 9-volt battery into the compartment. Make sure battery polarity is correct. (3) Frequency Labe. The Frequency label indicates what frequency (in MHz) the transmitter broadcasts on. The AZDEN receive. in

WIRELESS MICROPHONE SYSTEM. OWNER.S MANUA. 311DRH . 311DR . 221R . 211R . 200R31LT . 31IT . 32BT . 32IT . 31HT . 31XT AZDEN CORPORATIO. 147 New Hyde Park Roa. Franklin Square, NY 1101. 516.328.7500 vox . 516.328.7506 fa. azdenus@aol.com . Thank you for purchasing AZDEN.S .PERFORMANCE SERIES. wireless system. This manual covers th. 311DRH, 311DR, 221R, 211R and 200R receivers and the 32BT (Lavaliere), 31XT (Plug-in XLR), 31H. (Handheld), 31LT (Lavaliere) and 31IT (Instrument) transmitters. Receiv

Connect an audio cable from the output o. the receiver to a mic/line input on your audio mixer or amplifier. Plug the receiver.s AC adaptor into the 12. input jack on the receiver, and then plug it into the 110-120 VAC electrical outlet. With the volume of you. mixer or amplifier set to minimum level, turn your system.s power on. Turn on the transmitter(s). Make sur. all LEDs on the receiver and transmitter(s) are operating as described in the preceding pages. Now set th. receiver.s volume to th

If there is too much, or too little gain, adjust the volume on the receiver. If the soun. is distorted, move the microphone further away from the sound source. 31IT: Plug the cable into a guitar or bass. Set the instrument volume to the midway point. While playing th. instrument, adjust the volume on the mixer or amplifier to the desired level. If there is too much, or too littl. gain, adjust the volume on the receiver. If the sound is distorted lover the input gain on the 31IT. With th. system

the same frequency. (8. Output (balanced. Using a suitable audio cable (not supplied) connect the XLR connector to the audio output on the receiver, an. connect the other end of the cable to the suitable mic/line input of an audio mixer or amplifier. 221R Two-channel VHF receiver. The 221R contains two VHF receivers operating on different frequencies. This allows single or simultaneou. use of two transmitters. The receiver features two 1/4-inch output jacks and two volume adjustments - one forea

(24) Insert two fresh Alkaline* “AA” batteries* into the compartment. Make sure the battery polarity is correct as marked inside the battery compartment. *While Alkaline batteries are preferred, you can use rechargeable Ni-Cd or Ni-MH batteries. In the battery compartment you will also find #25 and #26: (25) MIC LEVEL Control: The MIC LEVEL control enables you to adjust the audio level of the microphone. Using the supplied tool, turn the dial clockwise to increase, or counterclockwise to decreas