Stimmen - 4, Durchschnittliche Bewertung: 4.5 ( )

Hersteller: AmpliVox Dateigröße: 100.04 kb Dateiname: 222%20operation.pdf Unterrichtssprache:

Optional Power Supplies may be substituted: Model S1460, International AC Adapter/Recharger (110/220V, 50/60Hz). Model S1462, 12 Volt DC adapter (automotive cigarette lighter plug- in). Model S1465, NiCad Battery Pack. TO INSTALL OR REPLACE BATTERIES Open carrying case cover. Lift out battery holder from case. Insert 10 new Alkaline “D” cell batteries, be sure to observe polarity, or replace with Model S1465 NiCad battery pack. Carefully replace battery pack. Do not mix battery types or attempt to recharge alkaline batteries - equipment damage, safety hazard or fire could result. TO OPERATE: Plug hand held microphone into DYNAMIC microphone jack. Turn amplifier on (large rocker switch located on the amplifier panel). The red light will show that power is available. Rotate MIC VOLUME control knob to obtain desired loudness level throughout the coverage area. SW222 – Turn amplifier on (large rocker switch located on amplifier panel) and turn internal wireless receiver on (top right of chassis). Attach lapel microphone to wireless transmitter and turn transmitter on (uses 9 volt battery). Insure transmitter and receiver are both on same frequency (A or B). Rotate MIC VOLUME control knob to obtain desired loudness level. ON-OFF When power switch is in the ON position, the red light will be on. DC IN Connection for optional power adapter: • S1460 International AC Adapter/Recharger (110/220V, 50/60Hz) • S1462 12 Volt DC (automotive cigarette lighter) Adapter LAMP Connection for 12 to15V DC accessory MONO-STEREO Combines the separate left and right AUX LINE IN channels. This combined signal will be amplified and appear on both the LEFT and RIGHT channels of the SPEAKER and LINEOUT OUTPUTS. VOLUME Rotate clockwise to increase amplification. MICROPHONE INPUTS There are three microphone inputs, which can be used simultaneously: DYNAMIC - for standard dynamic cartridge microphones CONDENSER - for electret or condenser microphones which require phantom power (Supplied from the amplifier) WIRELESS - accepts line-level output from wireless microphone receiver if using an S222 AUXILIARY To add pre-recorded music or sound effects during your presentation, just plug your CD player, tape player or computer sound card into the LINE IN jack. Separate VOLUME and TONE control knobs let you balance the program source with the live microphones. If using an external wireless receiver, for best sound quality it should be connected to the LINE IN jack. OUTPUT To tape record your speech or program, connect the LINE OUT on the amplifier to the input on a tape recorder. SPEAKERS Two separately amplified speaker jacks (4-8 ohms) allows you to use internal speaker and extension speaker for additional sound power or true stereo output. Unit speaker is wired internally. Plug external speaker into right speaker jack for stereo. Note: when using a stereo AUX source with a single speaker, only one of the stereo channels will be heard, switch stereo/mono switch to mono for both chann...

Herunterladen

Geben Sie zwei Ziffern: