Stimmen - 2, Durchschnittliche Bewertung: 4
(
)
)
|
Anleitung Zusammenfassung
You cannot overcharge the unit using the AC charging method. • All On/Off switches should be in the OFF position when the unit is charging or not in use. Make sure all switches are in the OFF position before connection to a power source or load. 3 90550871 Vec012CBD EN SP.qxp:VEC012CBD_ManualEN_080907 8/21/09 11:04 AM Page 4 • Do not use any accessory that is not recommended or provided by the manufacturer. • This system is designed to be used only on vehicles with a 12 volt DC battery system. Do not connect to a 6 volt or 24 volt battery system. • This system is not designed to be used as a replacement for a vehicular battery. Do not attempt to operate a vehicle that does not have a battery installed. • Excessive engine cranking can damage a vehicle’s starter motor. If the engine fails to start after the recommended number of attempts, discontinue jump-start procedures and look for other problems that may need to be corrected. • Do not use this jump-starter on a watercraft. It is not qualified for marine applications. • Although this unit contains a non-spillable battery, it is recommended that unit be kept upright during storage, use and recharging. To avoid possible damage that may shorten the unit’s working life, protect it from direct sunlight, direct heat and/or moisture. • Read And Understand This Instruction Manual Before Using This Unit. SAVE THESE INSTRUCTIONS THIS MANUAL CONTAINS IMPORTANT SAFETY AND OPERATING INSTRUCTIONS FOR THE START-IT® 450 AMP JUMPSTARTER/ AIR COMPRESSOR MODEL VEC012CBD. WARNING: TO REDUCE THE RISK OF INJURY: • Follow these instructions and those published by the battery manufacturer and manufacturer of any equipment you intend to use with this unit. Review cautionary markings on these products and on engine. INTRODUCTION Thank you for choosing the Black and Decker®Start-It®450 Amp Jump-Starter/ Air Compressor. This compact jump-starter is unique in the amount of energy it can supply for its size. The internal battery is a high density sealed, lead-acid battery that stores and delivers energy comparable to full sized ordinary jump-starters. Please read this guide carefully before use to ensure optimum performance and avoid damage to the unit or items that you are using it with. The Black and Decker®Start-It®450 Amp Jump-Starter/ Air Compressoris a compact, durable, portable jump- start system for vehicles that have a standard 12 volt battery system. This self-contained, rechargeable system will start most vehicles without the need for a host vehicle or 12 volt DC power supply. FEATURES • 450 instant starting amps • Keyless ON/OFF Power Switch • Built-in non-spillable, maintenance-free, heavy duty, 17 amp/hour, sealed, lead-acid battery • Easy-to-read LED battery charge status indicators • Reverse polarity connection warning indicator • Built-in portable inflator for vehicle tires and recreational inflatables • Cordless/rechargeable, includes 120 Volt AC Charging Adapter • Requires no maintenance (other than recharging) for optimum operation • Heavy duty cables and clamps • Exclusive cable storage channels keep jumper cables out of the way until needed 4 90550871 Vec012CBD EN SP.qxp:VEC012CBD_ManualEN_080907 8/21/09 11:04 AM Page 5 Controls and Indicators 6 1 2 4 5 3 108 9 7 11 Front View 1. CHARGING PORT FOR 120 VOLT AC CHARGING ADAPTER 2. BATTERY CHARGE LEVEL PUSHBUTTON 3. LED BATTERY STATUS INDICATORS 4. JUMP-STARTER POWER SWITCH 5. REVERSE POLARITY INDICATOR Back View 6. AIR PRESSURE GAUGE 7. INFLATOR POWER SWITCH 8. NEGATIVE (–) BLACK CLAMP 9. POSITIVE (+) RED CLAMP 10. CONNECTOR (CHUCK) 11. AIR HOSE NOZZLES Applications • Jump-start most vehicle batteries with a standard 12 volt DC system: small truck, car, RV, tractor, etc. • Inflate (using inflator) tires, air mattresses, basketballs, volley balls, and more. 120 VOLT AC CHARGING ADAPTER CHARGING/RECHARGING Lead-acid batteries require routine maintenance to ensure a full charge and long battery life. All batteries lose energy from self-discharge over time and more rapidly when they are at higher temperatures. Therefore, batteries need periodic charging to replace energy lost through self-discharge. When the unit is not in frequent use, Black & Decker recommends the battery be recharged at least every 60 days. Check the battery charge level by pressing the battery status button. The LED charge status display will indicate the level of battery charge. When only one red LED lights, recharge the unit. When the battery is overly discharged and if the green LED is lit when the charger is plugged in, this indicates the battery is at a high impedance stage. In this event, recharge the unit and leave the unit on charge for a period of 48hrs before using the unit. 5 90550871 Vec012CBD EN SP.qxp:VEC012CBD_ManualEN_080907 8/21/09 11:04 AM Page 6 Notes: This unit is delivered in a partially charged state – you must fully charge it before using it for the first time. Initial AC charge should be for 48 hours. Recharging battery after...
Dieses Handbuch ist für folgende Modelle:Pumps - Start-It VEC012CBD (379.59 kb)