Stimmen - 3, Durchschnittliche Bewertung: 3.7 ( )

Hersteller: Edelbrock Dateigröße: 64.6 kb Dateiname: Unterrichtssprache:

Consult your service manual for any other specific procedures. Caution: Be sure that the fan bolts don't protrude through the hub so far they hit the water pump housing. • SPECIAL NOTES : — Check closely for any interference with drive belts or pulleys. — If the engine is not using a water thermostat, a water flow restrictor plate should be used in place of the thermostat. The hole size needed in the restrictor plate may vary in size from 11/16" to 1" diameter depending on your water system. Use of a restrictor plate increases the water pressure in the block and cylinder heads and helps the radiator work more efficiently. — Edelbrock water pumps are designed to provide increased water flow, pressure and efficiency, the impeller and housing passages are designed to work with the pump rotating in the correct direction. This pump should only be used with clockwise, standard rotation (when view from the pulley side). This pump will not function properly if used in a reverse-rotation, counter-clockwise application. PARTS INCLUDED WITH THE WATER PUMP: 1 - Water Bypass Tube (To be installed in the pump housing prior to installation of the water pump) 1 - 5/8" x 3/8"NPT Heater Hose Nipple 1 - 3/8"NPT Pipe Plug 4 - 3/8"-16 UNC x 1.50" Bolt, 12 Point Head 4 - 3/8" AN Washer 2 - Gasket, Water Pump to Block SPECIFICATIONS Dimension from block surface to hub: 7.56", hub pilot diameter - 5/8" PLEASE complete and mail your warranty card. Be sure to write the model number of this product in the “Part #_” space. THANK YOU. 1998 Edelbrock Corp Rev. 11/98...

Herunterladen

Geben Sie zwei Ziffern: