Stimmen - 2, Durchschnittliche Bewertung: 4
(
)
)
|
Anleitung Zusammenfassung
After drying, fill with engine oil up to the specified level. * Clean more frequently if pump is operated in a dusty area. ELEMENT WARNING ★ Never use gasoline or low flash point solvents for cleaning the air cleaner element. A fire or explosion could result. EVERY I 00 HOURS CHANGE ENGINE OIL CLEAN FUEL FILTER CLEAN SPARK PLUG AND CHECK GAP O * Wash removed parts in high flash point solvent, dry them thoroughly and install securely. Turn the fuel valve ON and check for leaks. CHECK FUEL HOSE 0.6—0.7 mm (0.024-0.027 in) ★ Use NGK BR4HS spark plug. A. When the engine will not start: B. When the pump cannot pump the water: * Check fuel hose for cracks or leaks every 300 hours. Replace, if necessary. TROUBLESHOOTING SPECIFICATIONS Model WT20 WT30 Length x Width x Height 675 x 480 x 605 mm 690 x 485 x 655 mm (26.6 x 18.9 x 23.8 in) (27.2 x 19.1 x 25.8 in) Dry weight 55 kg (121 lbs) 62 kg (137 lbs) Engine type 4 cycle, side valve, 1 cyli nder, forced air cooled Displacement 197 cc (12.0 cu in) 272 cc (16.6 cu in) Ignition system Flywheel magneto Flywheel magneto Suction port diameter 50 mm (2 in) 80 mm (3 in) Discharge port diameter 50 mm (2 in) 80 mm (3 in) Total head 26 m (90 ft) 30 m (100 ft) Suction head 7 m (23 ft) 7 m (23 ft) Capacity 650V (170 US gal) 1,230t (320 US gal) MECHANICAL SEAL REPLACEMENT 1. Loosen the clamp handle knobs, pivot the clamp handles out as shown, then pull the pump cover out of the pump housing. 2. Pull the pump casing back, rotate it counterclockwise about 30°, and remove it from the housing. 3. Remove the impeller by turning it counterclockwise and remove the shims. Note the number of shims. 4. Replace the mechanical seal. Install the removed parts in the reverse order of removal. COVER PUMP CASING AH 31YB100 HONDA HONDA MOTOR CO.. LTD. TOKYO. JAPAN * y A20008202 PRINTED IN JAPAN CLAMP HANDLE MECHANICAL SEAL IMPELLER PUMP...
Dieses Handbuch ist für folgende Modelle:Pumps - WT20 (1.04 mb)