Stimmen - 2, Durchschnittliche Bewertung: 3
(
)
)
|
Anleitung Zusammenfassung
check the fuel level. Use any regular grade automotive gasoline (unleaded gasoline is preferred) with a pump octane rating of 86 or higher. Never use an oil/gasoline mixture or dirty gasoline. Avoid getting dirt, dust or water in the fuel tank. CAUTION: Gasoline substitutes are not recommended; they may be harmful to the fuel system components. ^warning • Gasoline is extremely flammable and explosive under certain conditions. Refuel in a well ventilated area with the engine stopped. • Do not smoke or allow flames or sparks in the area where the engine is refueled or where gasoline is stored. • Do not overfill the tank and make sure the filler cap is securely closed after refueling. • Be careful not to spill fuel when refueling. Fuel vapor or spilled fuel may ignite. If any fuel is spilled, make sure the area is dry before starting the engine. Fuel tank capacity WA20X .. . 2.6 lit. (0.66 US gal, 0.55 Imp gal) WA30X ... 3.6 lit. (0.95 US ga!. 0.79 Imp gal) 5 5. Check the air cleaner element. Remove the wing nut, washer and air cleaner cover. Check.the element for dirt or obstruction. Clean the element if necessary (see page 13). 6. Check the priming water. While the pump will self-prime with a minimum of 4.3 liters (4.6 US qt) for the WA20X, and 6.2 liters (6.6 US qt) for the WA30X, it is recommended that the water chamber be kept full. CAUTION: Never attempt to operate the pump without priming water or the pump will overheat. Extended dry operation will destroy the pump seal. If the unit has been operated dry, stop the engine immediately and allow the pump to cool before adding priming water. PRIMINQ WATER FILLER CAP I 6 4. STARTING THE ENGINE 1. Turn the fuel valve ON. 2. Close the choke lever. NOTE: Do not use the choke if the engine is warm or the ambient temperature is high. 3. Turn the engine switch to the ON position. 7 4. Move the throttle lever slightly to the left. 5. Pull the starter grip lightly until resistance is felt, then pull it briskly. CAUTION: Do not allow the starter grip to snap back against the engine. Return it gently to prevent damage to the starter. 8 5. OPERATION 1. As the engine warms up, gradually open the choke. 9 6. STOPPING THE ENGINE 1. Move the throttle lever fully to the right. 2. Turn the engine switch to the OFF position. 3. Turn the fuel valve OFF. THROTTLE LEVER High altitude operation At high altitude, the standard carburetor air-fuel mixture will be excessively rich. Performance will decrease, and fuel consumption will increase. High altitude performance can be improved by installing a smaller diameter main fuel jet in the carburetor and readjusting the pilot screw. If you always operate the water pump at altitudes higher than 6,000 feet above sea level, have your authorized Honda Water Pump dealer perform these carburetor modifications. Even with suitable carburetor jetting, engine horsepower will decrease approximately 3.5% for each 1,000 foot increase in altitude. The affect of altitude on horsepower will be greater than this if no carburetor modification is made. CAUTION: Operation of the Water Pump at an altitude lower than the carburetor is jetted for may result in reduced performance, overheating, and serious engine damage caused by an excessively lean air/fuel mixture. NOTE: To stop the engine in an emergency, turn the engine switch to the OFF position. 10 7. MAINTENANCE The purpose of the maintenance schedule and adjustment is to keep the engine in the best operating condition. Inspect or service as scheduled in the table below. Shut off the engine before performing any maintenance. If the engine must be run, make sure the area is well ventilated. The exhaust contains poisonous carbon monoxide gas. CAUTION: • If the pump has been used with sea water, muddy water, etc., pump clean, fresh water immediately afterward to reduce corrosion or remove sediment. • Use only genuine HONDA parts or their equivalent. The use of replacement parts which are not of equivalent quality may damage the engine. Maintenance Schedule \ REGULAR SERVICE PERIOD ITEM perform at every indicated monttTor^ operating hour interval, which > ever comes first. \ Each use First month or 20 Hrs. Every 3 months or 50 Hrs. Every 6 months or 100 Hrs. Every year or 300 Hrs. Engine oil Inspection o Change o O Air cleaner element Inspection o Cleaning °(1> Spark plug maintenance o Tappet clearance adjustment 0(2) Combustion chamber cleaning 0(2) Fuel tank cleaning 42» Spark arrester Clean every 100 operating hours. Fual line Replace every 3 years. Impeller inspection <-12) Friction disc inspection 0(2) Casing cover inspection 0(2) Inlet valve inspection 0(2) NOTE (1): Service more frequently when used In dusty areas. (2): These items should bG serviced by an authorized Honda dealer, unless the owner has the proper tools and is mechanically proficient. See the Honda S...
Dieses Handbuch ist für folgende Modelle:Pumps - WA30X (550.14 kb)