Stimmen - 3, Durchschnittliche Bewertung: 4.3 ( )

Hersteller: HP Dateigröße: 83.91 kb Dateiname: 9bde6baa-4f0e-4c93-b1a6-ccff9f51fefb.pdf Unterrichtssprache:

This unit is equipped with a dual volute pump casing. One of the volutes runs 180°, all the way from side opposite discharge into discharge through a completely enclosed passageway. If foreign material clogs this area, it can be dislodged by using a wire or long spring. REMOVAL OF OLD SEAL Refer to Figure 1 IMPORTANT: Always replace both seal seat (Ref. No. 10) and seal head (Ref. No. 11) to insure proper mating of components! Also, impeller seal washer (Ref. No. 14) should be replaced anytime impeller lock bolt (Ref. No. 15) has been removed. 1. Remove four bolts (Ref. No. 4) that connect adapter (Ref. No. 7) to casing (Ref. No. 16). 2. Remove casing and casing seal (Ref. No. 8). Care should be taken not to "pinch" or "shave" the o-ring gasket (Ref. No. 8) between adapter and casing. 3. Using an Allen wrench, remove impeller lock bolt, impeller seal washer, and impeller (Ref. No. 13). IMPORTANT: Care should be taken to insure that same number of shim washers (Ref. No. 12) are replaced behind impeller as were removed. These shim washers are located directly behind impeller. These washers as well as impeller key (Ref. No. 2) become loose as impeller is removed. 4. Seal head and shaft sleeve can now be pulled from shaft. 5. Pry seal seat from adapter. 6. Push seal head from shaft sleeve. INSTALLATION OF NEW SEAL The precision lapped faces on mechanical seal are easily damaged. Handle your replacement seal carefully. 1. Thoroughly clean all surfaces of seal seat cavity. 2. Using a clean cloth, wipe shaft and shaft sleeve and make certain that they are perfectly clean. 3. Wet the rubber portion of new seal seat with a light coating of soapy water. While wearing clean gloves or using a clean light rag, press seal seat squarely into adapter recess. Avoid scratching polished surface. If seal will not position properly, place a cardboard washer over polished surface and use a piece of pipe to press in, firmly but gently. 2874-251-00 Specifications Suction inlet ...................3" NPT Discharge outlet ................3" NPT Motor (TEFC) . . . 3 HP(Model 2874 & 2877) .............. 5 HP (Model 2875 & 2878) ................... 7.5 HP (Model 2876) Power Supply: Model 2874, 2875, 2876: ........... 230/460 VAC, 60 Hz, 3 Phase Models 2877 and 2878: ............... 230 VAC, 60 Hz, 1 Phase RPM .......................... 3600 Pump construction ............ Cast Iron Impeller material ......... Stainless Steel STD Mechanical Seal ..... Carbon/ceramic ........... Buna-N, S.S. springs and parts Liquid temp .... 40° to180° F (4° to 82° C) NOTE: Data is subject to change without notice. 4. Dispose of cardboard washer. Check again to see that polished surface is free of dirt and all other foreign particles and that it has not been scratched or damaged. 5. Wet the inside of rubber portion of new seal head with a light coating of soapy water. Slide head onto shaft sleeve. Slide shaft sleeve with seal head onto motor shaft. Seal head and seal seat will meet. Reinstall a...

Herunterladen

Geben Sie zwei Ziffern: