Stimmen - 4, Durchschnittliche Bewertung: 4.3
(
)
)
|
Anleitung Zusammenfassung
OD/DS MOD DELAY 1 OVERDRIVE CHORUS 0-99ms DELAY 2 BLUES PHASER 100-700ms DELAY 3 DISTORTION FLANGER REVERB 4 METAL TREMOLO - 5 FUZZ ROTARY - 6 COMPRESSOR -- Blank Chart BANK NO. OD/DS MOD SOLO SW TYPE DRIVE TONE LEVEL SW TYPE RATE DEPTH LEVEL 1 1 2 3 1 2 2 3 1 3 2 3 1 4 2 3 1 5 2 3 1 6 2 3 1 7 2 3 1 8 2 3 1 9 2 3 1 10 2 3 Blank Chart Blank Chart EQ WAH NS MASTER LEVELSW TYPE TIME FEEDBACK LEVEL LOW LOWMID HIGHMID HIGH SW THRESHOLD Type List NO. OD/DS MOD DELAY 1 OVERDRIVE CHORUS 0-99ms DELAY 2 BLUES PHASER 100-700ms DELAY 3 DISTORTION FLANGER REVERB 4 METAL TREMOLO - 5 FUZZ ROTARY - 6 COMPRESSOR -- Troubleshooting “bt” Appears in the Display > Batteries are run down. Replace with new batteries (p. 11). Power does not turn on . Is the correct AC adaptor (PSA series; sold separately) properly connected? > Check once more to confirm the adaptor is connected (p. 12). Never use any AC adaptor other than the adaptor specified. . Has the battery run down? > Replace with new batteries (p. 11). * The batteries included with the ME-20 are intended only for confirming that the unit is functional. * This unit consumes a large amount of current, so the use of an AC adaptor is recommended. If using batteries, use alkaline-type batteries. * To reduce battery consumption, be sure to disconnect the plug connected to the INPUT jack whenever the unit is not in use. . Is the plug properly connected to the INPUT jack? > Check the connection once again (p. 12). * The power will not turn on without a plug connected to the INPUT jack. No Sound/Volume is Low . Are the other devices properly connected? > Check the connection once again (p. 12). . Can you hear sound through the headphones when headphones are connected? > If you can hear sound, there may be a short in the cable used to connect the amp or other device, or a mistake in an external device’s settings. Check the connecting cables and external devices once more. . Could the MASTER LEVEL knob be turned down? > Use the MASTER LEVEL knob to raise the output volume. . Could the levels for OD/DS or EQ be too low? > Use the parameter knobs to raise the levels. . Is the volume turned down? > Check the volume levels on any connected amp or mixer. Check “LEVEL” and other volume parameters to make sure no volume setting is too low. . Could the level have been lowered with the expression pedal? > When the pedal is set to function as a volume pedal, sounds are not output when the toe of the expression pedal is in the raised position. . Is the ME-20 in Tuner mode? > In Tuner mode, the bypassed sound is output, and the expression pedal functions as a volume pedal. In this case, sounds are not output when the toe of the pedal is in the raised position. . Could you be using a cable with an embedded resistor to connect a CD or MP3 player to the AUX IN jack? > Use of a cable that contains a resistor may make sound from connected devices inaudible. Patches Cannot Be Switched . Is the ME-20 in Memory mode? > In Memory mode, the display indicates the bank, the pedal indicators show the current patch, and the effect-select indicators light. Conditions other than these mean the ME-20 is in another mode, so patches cannot be changed. First switch the ME-20 to Memory mode, then continue (p. 23). The Expression Pedal Switch Cannot Be Turned On or Off The Volume Pedal Cannot Reduce the Volume Completely . Could the expression pedal be out of adjustment? > Although the unit’s expression pedal has been set for optimal operation at the factory, extended use and certain operating environments can result in the pedal going out of adjustment. Adjust the expression pedal (p. 30). Specifications Specifications . AD Conversion 24-bit + AF method (*) . DA Conversion 24-bit . Sampling Frequency 44.1 kHz . Patches 30 (user) . Nominal Input Level INPUT: -10 dBu AUX IN: -18 dBu . Input Impedance INPUT: 1 M. AUX IN: 22 k. . Nominal Output Level -10 dBu . Output Impedance 2 k. . Display 7 segments, 2 characters LED . Control OD/DS/1 Pedal MOD/2 Pedal DELAY/3 Pedal Expression Pedal . Jacks INPUT jack (1/4” phone type) AUX IN jack (Stereo miniature phone type) OUTPUT jacks L/MONO, R (1/4” phone type) PHONES jack (Stereo 1/4” phone type) FOOT SW jack (1/4” TRS phone type) AC Adaptor jack . Power Supply DC 9 V: Dry batteries (R6/LR6 (AA) type) x 6, AC Adaptor (PSA series: Optional) . Current Draw 90 mA * Expected battery life under continuous use: Alkaline: 13 hours, Carbon: 3.5 hours These figures will vary depending on the actual conditions of use. . Dimensions 294 (W) x 179 (D) x 54 (H) mm 11-5/8 (W) x 7-1/16 (D) x 2-1/8 (H) inches Maximum height: 294 (W) x 179 (D) x 74 (H) mm 11-5/8 (W) x 7-1/16 (D) x 2-15/16 (H) inches . Weight 1.6 kg / 3 lbs 9 oz (including batteries) . Accessories Owner’s Manual Dry Batteries (Alkaline: LR6 (AA) type) x 6 Roland Service (Information Sheet) . Options AC Adaptor: BOSS PSA series Footswitch: BOSS FS-6, FS-5U Connection Cable: PCS-31 (Roland) (Stereo 1/4” phone plug-1/4” phone plug x...