Stimmen - 3, Durchschnittliche Bewertung: 4.3
(
)
)
|
Anleitung Zusammenfassung
Please make sure that the line voltage in your country meets the requirement. • Do not use the same socket used for any noise generating device(such as a motor or variable lighting system) or large power consuming device. • Make sure that the unit is switched off before connecting the power cable to the socket. • When disconnecting the power plug from the socket, do not pull the cord but hold the plug to avoid damaging the cord. • If the unit is not to be used for a long period of time, unplug the power cable from the socket. • It is normal for this unit to become hot while being operated. • The BOSS alkaline battery will last for about 20 hours.CThis varies depending on how you use the unit.) If the battery voltage drops, various symptoms are shown, such the Check indicator remains lit, the wave range is decreased, the sound is distorted, etc. To prevent that, replace the battery immediately. • When the unit is not to be used for a long period of time, remove the battery to prevent battery leakage. • Make sure that the polarity(+/-) of the battery is correct. • Before connecting this unit with other devices, switch this unit and all the other units off. LOCATION • Avoid using this unit in the following conditions: in excessive heat (where it may be affected by direct sunlight, near a heater, mounting on a heat generating unit, etc) in excessive humidity where it may be affected by dust places subject to high vibration. • Operating this unit near a neon, fluorescent lamp, TV or CRT display may cause noise interference or malfunction. If so, change the angle or position of the unit. • Operating this unit near a TV or radio may cause picture trouble to the TV and noise to the radio. If this happens, move the unit away from the TV or radio. • Placing a unit with a large size transformer, such as a power amplifier, right above this unit may cause hum. • Do not leave this unit in excessive heat for a long time. The shape of the cabinet may change. CLEANING • For cleaning the unit, use a dry and soft cloth. • Should the casing becomes dirty, use a cloth slightly dampened with water. • To remove grime, clean the casing with a cloth moistened with a neutral detergent, when wipe it dry with a soft cloth. • Do not use solvents such as paint thinner or alcohol for cleaning. OTHERS • Do not let any liquid or solid substance into the unit. • Do not give a strong shock to the unit. • Do not touch inside the unit to avoid electric shock and breakdown. • If the unit does not function properly, immediately switch it off, then call the shop or local Roland service center. *To use the Wireless System WS-100, no application for qualification or permit is required. CD OUTLINE OF THE DIVERSITY SYSTEM If the signals from the wireless transmitter are received by only one receiver, noise or sound drop may occur by moving the positions of the transmitter. This is because electric waves reflect the wall or ceiling and therefore interfere each other, causing the dead point where the level is very low. This could be resolved by moving the receiver to the place where the interference does not occur, but it is not possible in practice. The alternative is placing two receivers in different positions and use the one which gives higher receiving level. In this way, the noise or sound drop by interference can be reduced. The diversity system, based on this idea, provides two receivers in a case, automatically switching the outputs depending on the receiving level. PANEL DESCRIPTION